Weider WESY19541 user manual Arm Assembly, Washers 82. Do not tighten the Screws yet

8.	Attach the Shroud (17) to the Top Frame (4) with	8
	two M6 x 16mm Screws (62) and two M6
	Washers (82). Do not tighten the Screws yet.
	Attach the Shroud (17) to the brackets on the			4
	Stabilizer (2) with two M6 x 16mm Screws (62)
	and two M6 Washers (82). Make sure the brack-
	ets are inside the Shroud. Tighten the four			17
	Screws used in this step.		82
		62
	Tighten the Nylon Locknuts (56, 58) used in
	steps 2–7.
		62
		82
					2
				Bracket 82	62
	Arm Assembly	9
			56	7
9.	Grease the M10 x 77mm Bolt (79). Orient the Leg			Grease
	Lever (8) with the welded support on the side
			8
	shown. Attach the Leg Lever to the Front Leg (7)
	with the Bolt and an M10 Nylon Locknut (56). Do			79
	not overtighten the Locknut; the Leg Lever
	must be able to pivot easily.	Welded
		Support
10.	Grease the M10 x 77mm Bolt (79). Attach the	10		4
	Pivot Frame (5) to the Top Frame (4) with the Bolt
	and an M10 Nylon Locknut (56). Do not over-
	tighten the Locknut; the Pivot Frame must be
	able to pivot easily.
	Attach the two Arm Pins (40) to the Pivot Frame			Holes
		56		79
	(5) with two M4 x 20mm Self-tapping Screws		5
		69
	(69). Insert the Arm Pins into the two holes in the
	Upright (3).			3
			Grease
		40
				69
				40

9