Step for clarity | Weider WESY19541 guide

26. Wrap the High Cable (55) under a 90mm Pulley	26
(48). Attach the Pulley, a Cable Trap (51), and	26
(48). Attach the Pulley, a Cable Trap (51), and			55
two Half Finger Guards (43) at the upper hole in			55
the “U”-bracket (45) with an M10 x 51mm Bolt
(66) and an M10 Nylon Locknut. Make sure the	56 43		48
Cable Trap is oriented to hold the Cable in the	56 43		48
Cable Trap is oriented to hold the Cable in the
groove of the Pulley and that the Finger			51
Guards are on the outside of the “U”-bracket.			51
Guards are on the outside of the “U”-bracket.			66
			66
		45 43
27. Route the High Cable (55) up through the Top	27
Frame (4) and over a 90mm Thin Pulley (47).	27	55
Frame (4) and over a 90mm Thin Pulley (47).		55
Attach the Pulley inside of the Top Frame with the
M10 x 67mm Bolt (71) used in step 25, an 11mm	56
Spacer (49), an M10 Washer (57), and an M10	56	47
Spacer (49), an M10 Washer (57), and an M10	49	47	4
Nylon Locknut (56).			4
Nylon Locknut (56).
	57		71
			71
28. Route the High Cable (55) over a 90mm Pulley	28
(48) and down through the Top Frame (4). Attach	28
(48) and down through the Top Frame (4). Attach
the Pulley inside of the Top Frame with an M10 x	56
67mm Bolt (71), two M10 Washers (57), two	52	48
67mm Bolt (71), two M10 Washers (57), two
12mm Spacers (52), and an M10 Nylon Locknut
12mm Spacers (52), and an M10 Nylon Locknut	57	55
(56).	57	55	52 57
	4		52 57
	4		71
			71
29. Note: The shroud is shown removed in this	29
step for clarity.	29
step for clarity.
Thread an M12 Nut (84) all the way onto the High		55
Thread an M12 Nut (84) all the way onto the High
Cable (55). Place a Large Washer (85) on top of		84
the Weight Tube (24).		84
the Weight Tube (24).
Tighten the High Cable (55) into the Weight Tube		85
(24) until all the slack is removed from the cables.			24
Tighten the M12 Nut (84) against the Large
Washer (85).
	14

step for clarity.