Weider WESY16010 user manual Seat Assembly

Page 12

22.Attach the end of the Short Cable (23) to the Long “U”-Bracket (57) with a 1/4” Nylon Lock- nut (2) and a 1/4” Flat Washer (10). Do not completely tighten the Nylon Locknut; it should be threaded onto the end of the Cable until two threads are showing above the Nylon Locknut, as shown in the inset drawing.

CABLE ASSEMBLY

23.Attach the Backrest (41) to the Front Upright (42) with two 1/4” x 2 1/2” Screws (43) and two 1/4” Flat Washers (10).

SEAT ASSEMBLY

22

 

 

2

10

57

 

 

23

 

2

 

10

57

23

23

 

 

42

 

41

 

43 10

12

Image 12
Contents QUESTIONS? Model No. WESY16010 Serial NoCustomer HOT Line Table of Contents Important Precautions Using the Weider 8920 home gym. If you have Before YOU BeginFor your benefit, read this manual carefully before Assembly Following Tools not Included are Required for AssemblyRefer to drawing 2b. Align the hole Tighten the Nylon Locknuts yetTighten all Nylon Locknuts used in steps Through ARM Assembly Cable Assembly Cable Assembly 2117 Bracket Ball Crossbar Inset shows view From other sideSeat Assembly Locknut. The Leg Lever must pivot freely Seat Assembly Adjustment Adding Weights to the Weight CarriageAttaching and Removing the Seat Attaching the LEG Lever to the LOW Pulley StationEyebolt is positioned vertically on the Leg Lever Weight Resistance Chart Weight on Press ARM Butterfly ARM LOW Pulley High PulleyLbs LEG LeverTROUBLE-SHOOTING and Maintenance Tightening the CablesCable Diagram Long Cable 58 TOP ViewShort Cable Page Page Part LIST-Model No. WESY16010 Qty DescriptionExploded DRAWING-Model No. WESY16010 Ordering Replacement Parts Limited WarrantyIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT Remove this Part Identification Chart from the Manual 4 Square Inner Cap Square Outer Cap 2 Square Inner Cap