Weider WESY16010 user manual Refer to drawing 2b. Align the hole, Tighten the Nylon Locknuts yet

FRAME ASSEMBLY

ARM ASSEMBLY

2. Refer to drawing 2a. Press a 1” Inner Cap	2		2a	70		61
(61) into each end of the weight tube on the
		19
Weight Carriage (19). Note: The Square				19
						70
Slider Bushings (70) should be pre-assem-			61
bled to the Weight Carriage (19) and Weight		70
Stop (67).
Turn the Weight Stop (67) so that the hole in		67	Hole	70		67
the Weight Stop is oriented in the same direc-
tion as the hole in the bottom of the Rear
Upright (56). Make sure that the Square
Slider Bushing (70) is above the Weight		56	42
Stop. Slide the Weight Stop onto the Rear
Upright (56).
Refer to drawing 2b. Align the hole in the
Weight Stop (67) with the hole near the base
of the Rear Upright (56). Secure the Weight					65
Stop to the Rear Upright with a 5/16” x 2 3/4”			Hole
Bolt (11) and a 5/16” Nylon Jamnut (72). Now
slide the Weight Carriage (19) onto the Rear
Upright.			3
Press a 1” Square Inner Cap (65) into the	2b	56		4
Front Upright (42). Slide the Front Upright	19	67
(42) onto the 5/16” x 2 1/2” Carriage Bolts (1)
			1
in the Base (4). Hand tighten a 5/16” Nylon	72
Locknut (3) onto each Carriage Bolt. Do not			11
tighten the Nylon Locknuts yet.
3. Press a 1 3/4” Square Inner Cap (44) into
each end of the crossbar on the Top Frame	3			11
(55). Press two 1” Inner Caps (61) into the			55		61
top of the crossbar.			8	8		44
		27
Attach the Top Frame (55) to the Front		8
Upright (42) with two 5/16” x 2 3/4” Bolts (11),
two 5/16” Flat Washers (8), and two 5/16”	22		72	44		Crossbar
Nylon Locknuts (3). Attach the Top Frame to
the Rear Upright (56) with two 5/16” x 2 1/2”
Bolts (22), two 5/16” Flat Washers (8), and
two 5/16” Nylon Jamnuts (72). Press a 2”		56	3	42
Square Inner Cap (27) into the top of the
Rear Upright.
Tighten all Nylon Locknuts used in steps 1	4
through 3.
4. Press a 1” x 7/8” Plastic Bushing (26) onto
each welded spacer on the Press Frame (17).			17		Lubricate
Slide the Press Frame onto the Base (4) so
the Plastic Bushings are aligned with the indi-						59
cated tube in the base. Note: This will be a
tight fit. The Plastic Bushings should fit			21
onto the ends of the tube in the Base.
Lubricate a 3/8” x 8” Bolt (59). Attach the		4				Welded
						Spacers
Press Frame (17) to the Base (4) with the		Tube		26
3/8” x 8” Bolt and a 3/8” Nylon Locknut (21).

6