Weider WESY16010 user manual ARM Assembly

Page 7

ARM ASSEMBLY

5.Press a 1 3/4” Square Inner Cap (44) into the top of one of the Press Arms (46). Press a 1” Round Inner Cap (49) into each end of the handle on the Press Arm. Attach the Press Arm to one side of the Press Frame (17) with two 5/16” x 2 1/2” Bolts (22) and two 5/16” Nylon Locknuts (3).

Assemble the other Press Arm (46) in the same manner.

6.Identify the Right Arm (48) and the Left Arm (47). Note the position of the welded bracket on each Arm. Arm identification is very important for step 7.

7.Lubricate both axles on the Top Frame (55).

Slide the Right Arm (48) onto the right axle.

Note: Be careful not to confuse the Right Arm with the Left Arm (47); refer to step 6 to identify the Right Arm. Be sure that the upper end of the Right Arm is behind the indicated bracket on the Top Frame (55).

Tap two 1” Retainers (63) and a 1” Round Cover Cap (62) onto the right axle. Be sure that the teeth on the Retainers bend toward the Cover Cap, as shown in the inset drawing.

Attach the Left Arm (47) in the same manner.

Press 1 3/4” Square Inner Caps (44) into the lower ends of the Right and Left Arms (47, 48). Wet the lower end of each Arm with soapy water. Slide a Foam Pad (45) onto the lower end of each Arm.

5

 

44

 

 

 

 

49

44

 

 

 

49

46

49

 

 

 

46

22

 

 

 

3

 

 

17

6

 

 

Welded

 

47

Brackets

 

48

 

 

7

55

 

 

47

 

 

 

Bracket

 

Lubricate

 

Axle

48

63

 

 

 

 

62

45

44

 

 

45

 

55

 

 

 

 

63

 

 

62

7

Image 7
Contents Model No. WESY16010 Serial No QUESTIONS?Customer HOT Line Table of Contents Important Precautions Before YOU Begin Using the Weider 8920 home gym. If you haveFor your benefit, read this manual carefully before Following Tools not Included are Required for Assembly AssemblyTighten the Nylon Locknuts yet Refer to drawing 2b. Align the holeTighten all Nylon Locknuts used in steps Through ARM Assembly Cable Assembly Cable Assembly 2117 Bracket Ball Crossbar From other side Inset shows viewSeat Assembly Locknut. The Leg Lever must pivot freely Seat Assembly Adding Weights to the Weight Carriage AdjustmentAttaching the LEG Lever to the LOW Pulley Station Attaching and Removing the SeatEyebolt is positioned vertically on the Leg Lever LEG Lever Weight Resistance ChartWeight on Press ARM Butterfly ARM LOW Pulley High Pulley LbsTightening the Cables TROUBLE-SHOOTING and MaintenanceLong Cable 58 TOP View Cable DiagramShort Cable Page Page Qty Description Part LIST-Model No. WESY16010Exploded DRAWING-Model No. WESY16010 Limited Warranty Ordering Replacement PartsIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT Remove this Part Identification Chart from the Manual 4 Square Inner Cap Square Outer Cap 2 Square Inner Cap