Weider WEEVBE1409.0, 240 TC manual Repeat this step with the other two Long Pad Tubes

Page 10

12.Attach the Weight Tube (24) to the Leg Lever

(8) with an M8 x 58mm Bolt (72), two M8 Washers (73), a 13mm x 11.5mm Spacer (53), and an M8 Locknut (67).

Next, press the Leg Lever Bumper (42) onto the Weight Tube (24).

Apply grease to the barrel of an M10 x 54mm Bolt Set (56).

Attach the Leg Lever (8) to the bracket on the Front Leg (2) with the M10 x 54mm Bolt Set

(56). Make sure that the barrel of the Bolt

Set is inserted through both sides of the bracket on the Front Leg.

13.Insert a Long Pad Tube (54) into the indicated hole in the Leg Lever (8).

Slide a Large Foam Pad (25) onto each end of the Long Pad Tube (54). Then, press a Large Pad Cap (46) into each Large Foam Pad.

Repeat this step with the other two Long Pad Tubes (54).

12
	Grease			56	Bracket
	Grease
	67	8				42		56
		73				42	2
24			53		73		2
24			53		73	72
13
46	25			54			54
	25					8	54
						8
						54		25	46
						54			46

10

Image 10

Contents QUESTIONS? Model No. WEEVBE1409.0 Serial NoTable of Contents Important Precautions Assembled Dimensions Before YOU BeginPart Identification Chart Assembly See the inset drawing. Insert the Crossbar Pin Repeat this step for the other side of the weight bench M6 Washers 65. Do not tighten the Screws Yet Repeat this step with the other two Long Pad Tubes Repeat this step for the other side of the weight bench Tower 14 make sure that the Cable is Under the storage hookAdjusting the Backrest AdjustmentUse solvents to clean the weight bench Adjusting the Weight RestsUsing the FLY Arms Using the LEG LeverUsing the Curl PAD Using the LAT TowerKnob is in the hole in the Lat Tower Storing the Weight Bench Workout Guidelines Exercise GuidelinesFour Types of Strength Workouts Exercise FormR0909A Qty DescriptionExploded DRAWING-Model No. WEEVBE1409.0 R0909A Ordering Replacement Parts