Weider WEEVBE1409.0, 240 TC manual Repeat this step for the other side of the weight bench

Page 8

6.Orient the Backrest Support (17) so that the pins are facing downward.

Set the Backrest Support (17) in one of the sets of brackets on the Left and Right Uprights (6, 7).

7.Attach a Fly Arm Bumper (30) to the Left Upright (6) with a Bumper Knob (50).

Attach the other Fly Arm Bumper (30) to the Right Upright (7) in the same way.

8.Identify the Left Fly Arm (10), which has a pivot tube on the indicated side.

Apply grease to an M10 x 130mm Bolt (58).

Attach the Left Fly Arm (10) to the Left Upright

(6) with the M10 x 130mm Bolt (58), an M10 Black Washer (64), and an M10 Black Locknut (66).

Repeat this step for the other side of the weight bench.

	6	17
	Bracket	17
	Bracket	Pins
	7	Pins
		Bracket
		6
	7
	7
	30	6
		50
		30
	8

6
Pivot	64 66
Tube	64 66
58	10
58
Grease

8

Image 8

Contents QUESTIONS? Model No. WEEVBE1409.0 Serial NoTable of Contents Important Precautions Assembled Dimensions Before YOU BeginPart Identification Chart Assembly See the inset drawing. Insert the Crossbar Pin Repeat this step for the other side of the weight bench M6 Washers 65. Do not tighten the Screws Yet Repeat this step with the other two Long Pad Tubes Repeat this step for the other side of the weight bench Tower 14 make sure that the Cable is Under the storage hookAdjustment Use solvents to clean the weight benchAdjusting the Backrest Adjusting the Weight RestsUsing the FLY Arms Using the LEG LeverKnob is in the hole in the Lat Tower Using the LAT TowerUsing the Curl PAD Storing the Weight Bench Exercise Guidelines Four Types of Strength WorkoutsWorkout Guidelines Exercise FormR0909A Qty DescriptionExploded DRAWING-Model No. WEEVBE1409.0 R0909A Ordering Replacement Parts