Weider WESY2916.1 user manual Frame Assembly

Frame Assembly	1
1.
Before beginning assembly, make sure you
understand the information in the box on
page 8. See the PART IDENTIFICATION
CHARTS on pages 5 and 6 for help identify-			1	83
ing small parts.
Insert four M8 x 75mm Carriage Bolts (83) up		83
through the Base (1). Note: It may be helpful to
place a piece of tape over each Bolt head to	2
hold it in place.
2. Insert the two Weight Guides (18) into the
Stabilizer (3). Make sure that the indicated
holes in the Weight Guides are nearer the
floor.
Attach the Stabilizer (3) and the Weight Guides
(18) to the base (1) with two M10 x 85mm Bolts
(81), two M10 Washers (80), two 21mm Steel
Spacers (108), and two M10 Nylon Locknuts (77).		18
Do not tighten the Nylon Locknuts yet.
Next, attach the Weight Guides (18) to the		Holes
Stabilizer (3) with two M10 x 20mm Button
Screws (96). Then, attach the Stabilizer to the
Base (1) with an M8 x 75mm Carriage Bolt (83)
and an M8 Nylon Locknut (78). Do not tighten
the Nylon Locknut yet.
Attach the Upright (2) to the Base (1) with the two			80	81
indicated M8 x 75mm Carriage Bolts (83) and two	2	78
M8 Nylon Locknuts (78). Do not tighten the		77		80
Nylon Locknuts yet.		78
	78		83	3
		1	108
		83	96
3. Attach the Front Leg (10) to the Base (1) with the	3
two M8 x 75mm Carriage Bolts (83) and two M8
Nylon Locknuts (78). Do not tighten the Nylon		75	10
Locknuts yet.
		104
Attach the Leg Lever Bumper (75) to the Front		110	78
Leg (10) with an M4 x 16mm Self-tapping Screw
(110) and an M4 Washer (104). Make sure the		78
end of the Leg Lever Bumper is pointing up.
			83
			1
	9