3.Attach the Front Leg (8) to the Frame (2) with two M10 x 65mm Bolts (18), two M10 Washers (24), and two M10 Nylon Locknuts (19).
4.Tap three 45mm Square Inner Caps (21) into the ends of the Leg Lever (4) as shown.
Tap a 1Ó Round Inner Cap (23) into the indicated end of the Weight Tube (41).
Insert the Weight Tube (41) into the indicated hole in the Leg Lever (4). Press a 1Ó Angle Cap (29) onto the indicated end of the Weight Tube.
Note: If you purchased the optional olympic expansion kit, attach the olympic sleeve to the Weight Tube as shown in the accessory manu- al.
5.Lubricate an M10 x 72mm Bolt (40). Attach the Leg Lever (4) to the Front Leg (8) with the Bolt and an M10 Nylon Locknut (19).
Attach the Spacer (37) to the Leg Lever (4) with the M8 x 58mm Bolt (39), two M8 Washers (38), and an M8 Nylon Locknut (13). Note: The Spacer will fit tightly inside of the Leg Lever.
6.Press four 1Ó Square Inner Caps (12) into the indi- cated ends of the Backrest Tubes (5, 42). Press two 1Ó x 2Ó Inner Caps (36) into the ends of the adjustment tubes.
With the wide end of the Backrest (6) positioned as shown, attach the Backrest Tubes (5, 42) to the Backrest with four M6 x 38mm Screws (16) and four M6 Washers (25). Note: The Backrest
Tubes and Backrest must be oriented exactly as shown.
7
3 |
|
| |
19 |
|
| |
24 |
| 2 | |
|
| ||
18 | 19 |
| |
8 |
|
| |
4 | 21 |
| |
|
| ||
| 4 |
| |
21 |
|
| |
41 |
|
| |
|
| 29 | |
23 | 21 |
| |
|
| ||
5 |
|
| |
19 | 8 |
| |
4 |
|
| |
39 | 40ÐLubricate | ||
38 37 | |||
|
| ||
38 |
|
| |
13 |
|
| |
6 |
|
| |
6 |
| 12 | |
Wide |
| ||
End |
|
| |
5 |
| 25 | |
|
| ||
| 42 | 16 | |
12 | Adjustment | ||
Tubes | |||
25 | |||
16 | 25 |
| |
|
| ||
36 | 16 |
| |