Weider WESY91080 manual Make sure the Cable Trap 66 is positioned as shown

19.Attach two 3 1/2Ó Pulleys (15) to the weight support arm (A) on the Top Frame (55) with two 3/8Ó x 2Ó Bolts (12) and two 3/8Ó Nylon Locknuts (21).

20.Locate the Short Cable (23). It has a ball on one end and a threaded tip on the other.

Feed the threaded end of the Short Cable (23) between the pre-assembled 3 1/2Ó Pulley (15) and the hook (C) on the Top Frame (55). Next, route the Short Cable around the angled ÒVÓ-Pulley (6) on the Butterfly Upright (42) and then around the ÒVÓ-Pulley

(6) on the Left Butterfly Arm (47).

Make sure the Long Cable Trap (50) is positioned to hold the Cable in place. If necessary, adjust the position of the Long Cable Trap.

21.Move to the other side of the unit. Route the Short Cable (23) around the ÒVÓ-Pulley (6) on the Right Butterfly Arm (48). Make sure the Long Cable Trap (50) is positioned as shown.

Tighten the Bolt and Locknut on the pulley bracket

(D).

Tighten the Bolt and Locknut on the pre-assembled Pulley (15) attached to the pulley bracket (D). Route the Short Cable (23) around the Pulley in the direc- tion shown. Make sure the Long Cable Trap (50) is positioned to hold the Cable in place.

22.Attach the 3 1/2Ó Pulley (15) and a Cable Trap (66) to the two ÒIÓ-plates (81) with a 3/8Ó x 2Ò Bolt (12) and a 3/8Ó Nylon Locknut (21).

Make sure the Cable Trap (66) is positioned as shown.

Route the Short Cable (23) around the Pulley (15) attached to the ÒIÓ-plates in the direction shown.

Route the Short Cable (23) through the first 3 1/2Ó Pulley (15) on the weight support arm (A).

19	A
55
		12
21		15
20		6
	55
C		50
15	23
	42
	47
21
D
		6
15		50
		48
	23
22	A	23
15
		21
81		81
12		66
		15

11