Weider WESY91080 manual Locate and open the parts bag labeled ÒSeat Assembly.Ó

33.Remove the 3 1/2Ó Pulley (15) from the Long ÒUÓ- Bracket (57).

Route the Medium Cable (86) around the Pulley in the direction shown.

Re-attach the Pulley to the Long ÒUÓ-Bracket (57) with the 3/8Ó x 2Ó Bolt (12) and the 3/8Ó Nylon Locknut

(21). Make sure the Cable Trap (66) is positioned as shown.

34.Attach the closed loop on the end of the Medium Cable (86) to the Top Frame (55) with a 5/16Ó x 2 3/4Ó Bolt (11), a 5/16Ó Flat Washer (8) and a 5/16Ó Nylon Locknut (3).

Make sure the flat side of the closed loop is turned towards the Top Frame.

Seat Assembly

35.Locate and open the parts bag labeled ÒSeat Assembly.Ó

Attach the Backrest (41) with the name decal to the Press Upright (56) with two 1/4Ó x 2 1/2Ó Screws (43) and two 1/4Ó Flat Washers (10).

36.Insert the 1/4Ó x 2 1/2Ó Carriage Bolt (91) into the cen- ter hole in a Seat Plate (37). Attach the Seat Plate to a Seat (13) with two 1/4Ó x 3/4Ó Screws (18).

Insert the 1/4Ó x 2 1/2Ó Carriage Bolt (91) into the indi- cated hole in the Press Seat Frame (77). Tighten a 1/4Ó Nylon Locknut (2) with a 1/4Ó Flat Washer (10) onto the Carriage Bolt.

33	86
		15
	66	21
	12	57
34
	55	86
		8
		11
		3

35
41	10
	43
	56
	10
	43
36
91	13
37	18
77	10
	2

15