Attaching the Lat Bar or Nylon Strap to the Low Pulley Station
Attach the Lat Bar (54) to the Medium Cable (86) with a Cable Clip (53). For some exercises, the Chain (52) should be attached between the Lat Bar and the Long Cable with two Cable Clips. Adjust the length of the
Chain between the Lat Bar and the Long Cable so the Lat Bar is in the correct starting position for the exer- cise to be performed.
The Nylon Strap (39) can be attached in the same manner.
Attaching the Leg Lever to the Low Pulley Station
To use the Leg Lever (29), the seat must be attached to the Butterfly upright (see ATTACHING AND REMOVING THE BUTTERFLY SEAT on page 20).
Attach one end of the Chain (52) to the Medium Cable
(86)with a Cable Clip (53). Attach the other end of the Chain to the Eyebolt (35) with a Cable Clip. Always remove the Chain (52) from the Eyebolt (35) before removing the seat.
Adjusting the Position of the Foot Plate
To adjust the position of the foot plate, pull out the Small Lock Pin (90). Move the Adjustment Tube (88) to the desired position and
39 |
52 |
86 |
53 |
54 |
52 |
53 |
29 |
35 |
86 |
88 |
90 |
21