17.Attach a Press Arm (7) to one side of the Press Frame (12) with two 5/16Ó x 2 1/2Ó Bolts (39) and two 5/16Ó Nylon Locknuts (40).
Attach the other Press Arm (7) to the Press Frame
(12)in the same manner.
18.Press a 1Ó Round Inner Cap (70) into the indicated end of one Press Arm (7). Press a 1 3/4Ó Square Inner Cap (48) into the Press Arm.
Repeat this step for the other Press Arm (not shown).
19.Lubricate both axles on the Butterfly Frame (3).
Refer to the drawing and identify the Right Arm (5) and the Left Arm (6).
Press a 1 3/4Ó Square Inner Cap (48) into the upper end of the Left Arm (6). Slide the Left Arm onto the indicated axle. Note: Be careful not to confuse the
Left Arm with the Right Arm (5). Be sure that the upper end of the Left Arm is behind the indicated bracket on the Butterfly Frame (3).
IMPORTANT NOTE: Before assembling the 1Ó Retainers (45) used in this step, be sure that you thoroughly understand the step. The Retainers can be assembled only once. If they must be removed, you will need to order new Retainers.
Tap two 1Ó Retainers (45) and a 1Ó Round Outer Cap (46) onto the axle. Be sure that the teeth on the
Retainers bend toward the Round Outer Cap, as shown in the inset drawing.
Attach the Right Arm (5) in the same manner.
17 |
|
|
| 39 | 7 |
| 7 | 40 |
|
| |
| 12 |
|
18 | 48 |
|
|
| |
|
| 70 |
| 7 |
|
19 |
|
|
| 3 |
|
Lubricate Axle
548
Bracket 45
46
6
Axle
45
46
10