Trouble-shooting and Maintenance

Inspect and tighten all parts each time you use the home gym system. Replace any worn parts immediately. The home gym system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents.

TIGHTENING THE CABLES

Woven cable, the type of cable used on the home gym system, can stretch slightly when it is first used. If there is slack in the cables before resistance is felt, the cables should be tightened. If any slack is felt when using the weight stack closest to the ab upright, both the High Cable (85) and the Low Cable (86) will need to be tight- ened. If any slack is felt when using the other weight stack, the Rear Cable (87), the Press Cable (88), and the Butterfly Cable (89) will need to be tightened.

To tighten the cables, first insert the weight pin into the mid- dle of the weight stack. Slack can be removed from these cables several ways:

¥See drawing 1. Tighten the 1/4Ó Nylon Locknut (44) that connects the end of the Press Cable (88) to the Large ÒUÓ Bracket (84).

¥See drawing 1. Remove the 3/8Ó Nylon Locknut (42) and the 3/8Ó x 2 1/4Ó Bolt (99) from the Pulley Covers (94), Pulley and Large ÒUÓ Bracket (84). Re-attach the Pulley and Pulley Covers to the other hole in the Large ÒUÓ Bracket. Orient the wide tab on the Pulley Covers as shown and make sure the Cable and Pulley move smoothly.

¥See drawing 2. Loosen the 1/2Ó Plain Nut (98) on the end of the High Cable (85). Thread the Cable further into the spider nut (not shown) in the end of the Weight Tube

(25). If the Cable needs to be tightened further, the 1/2Ó x 1 1/4Ó Weight Spacer (32) can be removed. The Rear Cable (87) can be tightened in the same manner.

¥See Drawing 3. If you feel additional slack while using the home gym system, the Low Cable (86) and the Press Cable (88) can be tightened further.

Remove the 3/8Ó x 2 1/4Ó Bolts (99), the 3/8Ó Nylon Locknuts (42), the 3 1/3Ó Pulleys (82), and the Pulley Covers (94) from the Pulley Plates (31). Re-attach the upper Pulley without the Cable Trap. Re-attach the lower Pulley to the higher hole in the Pulley Plates with- out the Cable Trap. Keep the Cable Traps for future use. Be sure that the Cable and Pulley move smoothly.

Do not overtighten the cables. If the cables are overtight- ened, the top weight will be lifted off the weight stack.

If a cable tends to slip off the pulleys often, it may have become twisted. Remove the cable and re-install it.

1	94
	94	82
		82
Wide Tab
	42	94
	42
	84	99
	84
	44	88
2			87
	85		87
	85
	98
	32
		25
3	82
	82
	99	31	42
		31

Wide Tab		82
	94	94
	86, 88

If the cables need to be replaced, see ORDERING REPLACEMENT PARTS on the back cover of this manual.