USING THE REMOVABLE RESISTANCE BARS
The Removable Resistance Bars (36, 67) can be used to exercise apart from the resistance system, as shown in the video or on the exercise guide. To remove a Resistance Bar, pull it out of the Tray (35).
To replace the Removable Resistance Bars (36, 67), slide them into the Tray (35) from the side shown, so that the arrows on the rings point toward the Tray.
Make sure the rings are pushed against the Tray.
STORING THE RESISTANCE SYSTEM
To store the resistance system, make sure the Seat
(13)is in the position closest to the Front Leg (6) (see ADJUSTING THE SEAT on page 12). Next, remove the Storage Knob (30) from the Upright (3). Lift the Front Leg toward the Top Upright (4), and tighten the Storage Knob into the side of the Upright and the Bench Rail (5).
Remove all of the resistance bars from the
To move the resistance system, place the toe of your shoe on the end of the Base (1) and hold the resist- ance system in the indicated area. Tilt the resistance system back onto the Wheels (31) and roll it to the new location. Be careful not to let the Front Leg (6) pinch your hands when you tilt the system back.
WARNING: Make sure that all of the resistance bars are removed from the “U”- channels before moving the resistance bar assembly to the stored position.
Make sure that the resistance bar assembly is in the horizontal position, and that the Storage Knob (30) is in place and fully tightened each time the resistance system is used.
67 |
|
| |
36 |
|
| |
| 35 |
| |
Rings |
|
| |
Resistance |
|
| |
Bars | 4 |
| |
|
| ||
44 | |||
|
| ||
| 43 |
| |
| 3 |
| |
30 | 80 |
| |
13 |
|
| |
6 |
|
| |
Stored Position |
| ||
| 6 |
| |
Hold in |
|
| |
this area |
|
| |
30 | 5 |
| |
|
| ||
| 1 | 31 | |
|
| ||
14