ADJUSTMENTS
This section explains how to adjust the resistance system. See the EXERCISE GUIDELINES on page 16 for important information about how to get the most benefit from your exercise program. Also, refer to the accompa- nying exercise guide to see the correct form for each exercise.
Make sure all parts are properly tightened each time the resistance system is used. Replace worn parts immedi- ately. The resistance system can be cleaned with a damp cloth and a mild,
ADJUSTING THE SEAT
The Seat (13) can be secured in any of five positions on the Bench Rail (5). To move the Seat, pull the Seat Knob (45) out as far as it will go, and slide the Seat to the desired position. Engage the Seat Knob into an adjustment hole in the Bench Rail. Note: It may be necessary to lift up on the Seat in order to engage the Seat Knob.
To perform row exercises, the leg press strap must be attached to the long cable (see ATTACHING THE ACCESSORIES, on page 13), and the Seat Carriage
(12)must be able to roll along the Bench Rail (5). First, remove the Backrest (14) from the Seat Carriage (see ADJUSTING THE BACKREST, below). Then, pull the Seat Knob (45) out as far as it will go, and turn the Knob so that the pin rests at the end of the
ADJUSTING THE BACKREST
The Backrest (14) can be used in a level position or one of three inclined positions. To use the Backrest in a level position, secure the Seat Carriage (12) to the adjustment hole in the Bench Rail (5) next to the Front Leg (6) (see ADJUSTING THE SEAT, above).
To use the Backrest (14) in an inclined position, secure the Seat Frame (12) to one of the three adjustment holes in the Bench Rail (5) closer to the Upright (3). Rest the Backrest against the Upright.
For row exercises, remove the Backrest (14). Hold the Backrest vertically over the Seat (13) and lift the rod out of the slot in the Seat Carriage (12) (see the inset drawing).
14 |
|
13 |
|
45 |
|
12 |
|
5 |
|
| |
| 12 |
Pin | 45 |
| |
Rod |
|
15 | 3 |
| |
Slot |
|
12 |
|
13 |
|
14 |
|
5 |
|
12 |
|
6 |
|
12