Weider WESY3873.2 user manual Locate the Long Cable 80. Insert one end

15. Locate the Long Cable (80). Insert one end of	15
the Cable through the welded tube on the indicat-
ed end of the Cross Tube (11) and then through a				80
Swivel Arm (22). If necessary, use the tip of a					71
screwdriver to pull the end of the Cable out of the				10
Swivel Arm. Be sure the Cable is on the indicat-
			11
ed side of the welded rod in the Swivel Arm.
Insert the Swivel Arm (22) into the welded tube			28		22
on the Cross Tube (11). Secure the Swivel Arm
with an M4 x 5mm Screw (10).					Rod
Wrap the Long Cable (80) around a 90mm Pulley					76
(28). Attach the Pulley inside of the Swivel Arm
(22) with an M10 x 42mm Button Head Bolt (71)
and an M10 Nylon Locknut (76).
16. Wrap the Long Cable (80) around a 90mm Pulley	16
(28). Attach the Pulley and a Pulley Guard (29) to			Flat
the indicated M10 x 140mm Carriage Bolt (73)			Edge	29	76
with an M10 Nylon Locknut (76). Make sure the
flat edge of the Pulley Guard is on the side
shown.					80
					28
			73
17. Attach a Pulley Housing (56) to the indicated “U”-	17
channel on the 10-pound Center Resistance Bar
(44) with an M10 x 102mm Button Head Bolt (24),
two Pivot Bushings (74), and an M10 Nylon
Locknut (76).
Wrap the Long Cable (80) around a 90mm Pulley		44
		76
(28). Attach the Pulley inside of the Pulley
				“U”-channel
Housing (56) with an M10 x 42mm Button Head	74
Bolt (71) and an M10 Nylon Locknut (76).				76
	71
			56
	28		74
		80	24
18. Wrap the Long Cable (80) under a 90mm Pulley	18
(28) as shown. Attach the Pulley and a Pulley
Guard (29) to the Upright (3) with an M10 x
113mm Button Head Bolt (40) and an M10 Nylon	3
Locknut (76). Make sure the flat edge of the			28
Pulley Guard is on the bottom.
			76
			29	80
	40
			Flat
		Edge
	10