2.Attach a Wheel (31) to the outside of the Base (1) with an M10 x 108mm Bolt (81), three M10 Washers (75), and an M10 Nylon Locknut (76).
Do not overtighten the Nylon Locknut; the Wheel must be able to turn easily.
Attach the other Wheel (not shown) in the same manner.
3.Press a 38mm x 64mm Inner Cap (41) into each end of the Cross Tube (11).
Orient the Cross Tube (11) as shown, with the welded tubes at the bottom. Attach the Cross Tube to the Upright (3) with two M10 x 140mm Carriage Bolts (73), two M10 Washers (75), and two M10 Nuts (47).
4.Press the 38mm x 76mm Dome Cap (87) into the indicated end of the Bench Rail (5). Press a 38mm x 76mm Inner Cap (34) into the other end of the Bench Rail.
Press two 50mm Square Outer Caps (27) onto the ends of the Front Leg (6).
Attach the Bench Rail (5), with the hole on the top, to the Front Leg (6) with two M10 x 68mm Screws (61).
5.Lubricate an M10 x 103mm Bolt (66) with grease. Attach the Bench Rail (5) to the Upright (3) with the Bolt and an M10 Nylon Locknut (76). Do not overtighten the Locknut; the Bench Rail must be able to pivot easily.
Tighten the Storage Knob (30) into the Upright (3) and the Bench Rail (5).
2 |
|
|
|
|
|
| 76 | 75 |
|
|
|
|
| |
|
|
|
| 75 |
|
|
|
| 81 |
|
|
| 31 |
|
|
| 1 |
|
|
3 | 41 |
|
|
|
|
|
|
| |
| 3 |
| 75 | 47 |
|
|
|
| Welded |
|
|
|
| Tube |
|
|
| 11 |
|
| 73 |
|
| 41 |
4 |
|
| Hole |
|
|
|
|
| 34 |
| 5 |
|
|
|
| 87 |
|
|
|
| 6 |
|
|
|
| 61 |
|
|
|
| 27 |
|
|
|
| 27 |
|
|
|
5 |
|
| 30 | 3 |
|
|
| ||
| Insert the bolt |
| 76 |
|
| through this hole |
|
|
|
| 5 |
|
| 66 |
|
|
|
| |
|
|
| Lubricate | |
6