Hotpoint NLL113 operating instructions Safety, Instructions Operating, Use copper, Conductors only

3-Wire System for Electric Dryers—DO NOT use for Mobile Home Installations

Safety

1 Remove the screws securing the terminal block access cover and the strain relief mounting bracket located on the back of the dryer upper corner.

2 Install a UL-approved strain relief into the power cord entry hole of the mounting bracket. Use

a strain relief which attaches to the mounting bracket with a nut. Finger-tighten the nut only at this time.

3 Thread a UL-approved 30A, 240V, 3 #10 AWG minimum copper conductor power cord through the strain relief.

4 Attach the power cord neutral (center wire) conductor to the silver-colored center terminal on the terminal block. Tighten the screw securely.

5 Attach the remaining two power cord outer conductors to the outer brass-colored terminals on the terminal block. Tighten both screws securely.

WARNING: Do not make a sharp bend or crimp wiring/conductor at connections.

Instructions Operating

Green ground screw

Silver terminal

6 Reattach the strain relief mounting bracket to the back of the dryer with two screws. Tighten screws securely.

Green neutral
ground wire	Nut

Tighten nut to these threads

Use copper	Power cord
conductors only.	Strain relief
	mounting bracket

7 Tighten the fasteners securing the cord restraint firmly against the power cord.

8 Tighten the strain relief nut securely so that the strain relief does not turn.

9 Reinstall the terminal block access cover.

4-Wire System for Electric Dryers—MUST be used for Mobile Home Installations

1 Remove the screws securing the terminal block access cover and the strain relief mounting bracket located on the back of the dryer upper corner.

2 Install a UL-approved strain relief in the entry hole of the mounting bracket. Use a strain relief which attaches to the mounting bracket with a nut. Finger-tighten the nut only at this time.

3 Remove the green neutral ground wire from the green ground screw located above the terminal block.

Typical 4		Black 240V
conductor	Typical	White neutral
receptacle	4 conductor cord

Red 240V

Green ground

4 Thread a UL-approved 30A, 240V, 4 #10 AWG minimum copper conductor power cord through the strain relief.

5 Attach the green power cord ground wire to the cabinet with the green ground screw.

6 Attach the white (neutral) power cord conductor from the power cord and the green ground wire from the dryer harness to the silver- colored center terminal on the terminal block. Tighten the screw securely.

7 Attach the red and black power cord conductors to the outer brass-colored terminals on the terminal block.

Green ground	Green power cord ground wire
	Silver terminal
screw

Green neutral			Terminal block
		Black
ground wire
Red	White Nut			Tighten nut to
				these threads

Strain

relief

Power cordmounting bracket

WARNING: Do not make a sharp bend or crimp wiring/conductor at the connections.

8 Tighten the fasteners securing the cord restraint firmly against the power cord.

9 Tighten the strain relief nut securely so the strain relief does not turn.

10 Reinstall the terminal block access cover.

15

Instructions Installation Instructions Troubleshooting Tips Consumer Support