If you have selected the 
, the zero will not flash.
14 Programme progress display
By selecting the wash programme, the pilot lights corresponding to the various phases making up the programme come on.
After the machine has started, only the running phase pilot light stays on. When the programme has
finished, the End 
pilot light comes on.
ENGLISH
13 START/PAUSE button 
This button has three functions:
Start - Pause - Draining of water/Spin
Start
After having selected the required programme, press this button to start the machine; the corresponding pilot light stops flashing.
If you have selected the delayed start, the machine begins its countdown. The duration of the programme or the delay appears on the display.
Pause
To interrupt a programme which is running, depress the Start/Pause button: the corresponding pilot light starts start to flash.
To restart the programme from the point at which it was interrupted, press the START/PAUSE button again.
Draining of water/Spin
By depressing the Start/Pause button
•The water of programme “A” (Soak) is emptied out
•The water of the last rinse on programmes with
option is emptied out and the laundry is spun.
The END 
pilot light flashes in the event of operating problems.
At the same time one of the following lights starts to flash and an alarm code appears on the display.
E10 + 
= the machine does not fill
E20 + 
= the machine does not empty
E40 + 
= the door has not been closed
To eliminate the problem, see paragraph “Something not working”.
If at the end of the programme the pilot light 
flashes this means that the drain filter must be cleaned.
Functions
End of programme
When the door locked light has gone out, the door
can be opened. The light 
(END) on the programme progress display illuminates. A flashing zero appears on the display.
Switch the machine off and remove the laundry. Turn the programme selector dial to O.
Altering a programme
You can alter the programme before it starts. When the programme has started, you can only reset it by turning the programme selector dial to O and then you can select the new programme.
Start it by depressing the START/PAUSE button.
Interrupting a programme
Depress the START/PAUSE button to interrupt a programme which is running, the corresponding light
13