Water inlet
Attention!
•An inlet hose is supplied and can been found inside the machine drum.
•Do not use the hose from your previous machine to connect to the water supply.
•This appliance must not be connected to the hot water system.
1.Open the porthole and extract the inlet hose.
2.Connect the hose with the angled connection to the machine.
Important!
Do not place the inlet hose down- wards. Angle the hose to the left or right depending on the position of your water tap.
3. Set the hose correctly by loosening the ring nut. After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks.
4.Connect the hose to a tap with a
3/4” thread.
Always use the hose supplied with the appliance.
Installation should comply with local water authority and building regula- tions’ requirements. A minimum water pressure of 0.05
MPa (0.5 bar) is required for safe op- eration of the appliance.
If you cannot make the cold water
connection direct from the rising mains, you may be able to operate the appliance from your cold water storage system.
There should be a minimum distance of 5.02m (16.5 ft) between the appliance’s inlet and the bottom of the water storage tank.
31