Electrolux LAVAMAT 62800 manual Been removed

Problem	Possible cause	Remedy
	The transport lock has not	Removing the transport lock.
The washing machine	been removed.
vibrates when operating	The screw feet not correctly	Adjust the feet as described
or is not stable.
		in the installation and con-
	adjusted.
		nection instructions.
Washing has not been	Only a few large items of	Always load the drum as full
		as possible. Mix large and
spun.	washing in the drum.
		small items.
	Screw connection on the in-	Tighten inlet hose.
	let hose is leaking.
	Drain hose is leaking.	Replace drain hose.
Water is leaking out un-	Drain pump cover is not	Close cover properly.
derneath the washing	closed properly.
machine.	Washing was caught in the	Load washing carefully for
	door.	the next wash.
	Emergency drain hose is	Close off emergency drain
	leaking.	hose properly.
Washing water is foam-
ing excessively. At the	Probably too much deter-	Dose detergent exactly as in-
end of the washing cy-	gent has been used.	structed by manufacturer.
cle, spin stops.
	Kink in drain hose.	Remove kink.
	Maximum pumping height	Please contact Customer
E20 appears.	of 1m exceeded.	Care Department.
ENDdisplay flashes 2x,		Switch off appliance. Pull out
at the same time an
		mains plug.
acoustic signal sounds	Drain pump is blocked.
		Clean drain pump. Remove
2x.
		foreign bodies from pump
(Problems with water
		housing.
outflow)
	With connection to sink
	outlet: sink outlet is	Clean out sink outlet.
	blocked.
Fabric softener not	Conditioner insert in the	Clean detergent dispenser
rinsed in, w compart-	compartment for additives
		drawer, insert conditioner in-
ment for additives is	is not correctly attached or
		sert firmly.
filled with water.	is blocked.

20