Electrolux L 12720 VIT manual Electrical connection, Permanent connection

Page 49

Installation

Electrical connection

This machine is designed to operate on a 220-230 V, single-phase, 50 Hz supply.

Check that your domestic electrical installation can take the maximum load required (2.2 kW), also taking into account any other appliances in use.

Connect the machine to an earthed socket.

The manufacturer does not accept any responsibility for damage or injury through failure to comply with the above safety precaution.

Permanent connection

In the case of a permanent connection it is necessary that you install a double pole switch between the appliance and the electricity supply (mains), with a minimum gap of 3 mm between the switch contacts and of a type suitable for the required load in compliance with the current electrical regulations.

The switch must not break the yellow and green earth cable at any point.

This operation must be performed by a qualified electrician.

49

Image 49

Contents Lavamat Turbo L 12720 VIT Dear customer Contents Programme charts wash and special programmes Contents Technical data Service General safety Safety instructionsPositioning, connection, starting up Follow the instructions for positioning and connectionProper use Child safetyTips for environmental protection DisposalPackaging materials MachineMain features of your washer-dryer Front view Description of the applianceProgramme selector dial Control panelON/OFF button Delay Start buttonMains-on light START/PAUSE buttonProgramme Option buttons Drying Time buttonRinse Hold Programme progress display DisplayAltering an option/programme which is running Cancelling a programmeOpening the door after the programme has started Before the first wash Detergent dispenser drawerSorting out and preparing the laundry Preparing the wash cycleTypes of fabric and care labels Sort of laundry Approximate Dry weightsCotton SyntheticsWoollens and particularly delicate items Delicates 40Detergents and additives Load Preparing the drying cycleGarments not suitable for drying Sort of laundryDuration of the drying cycle Drying symbols on garment labelsFibre residue Additional drying Switching the machine on How to washLoad the laundry Add detergent and additiveSelection of the Extra Rinse option Selection of the Delay Start optionStarting the programme At the end of the programme How to dryDrying only NON-STOP programme Automatic washing and dryingWash programmes Programme chart60E Type Special programmesMax Consumption Laundry 1200 DryingDegree of drying Consumption data for dryingMax Water Energy Duration Load Litres Periodical cleaning Exterior Cleaning and maintenanceAfter each wash Detergent dispenser drawerDrain filter Door sealWater inlet filter Emergency emptying out Frost precautionsProblem Possible cause Solution TroubleshootingSomething not working? Possible cause Solution ProblemNoisy Feet have not been E10 Problem Possible causeE20 If grey stains remain on the laundry Unsatisfactory washing resultsFoam is still visible even after the last rinse White residue is left on the laundryThis appliance complies with the following EC directives Technical data914601208 ServiceSafety instructions for the installer Instructions for installation and electrical connectionRear view Front view and side viewUnpacking InstallationLevelling PositioningWater drainage Water inletPermanent connection Electrical connectionConnect the machine to an earthed socket Building-in Preparation and assembly of the doorDoor HingesCounter-magnet Mounting the door132.986.960-01-0305