34electrolux Something not working
Something not working
Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Centre, please carry out the checks listed below.
During machine operation it is possible that it is possible that red Start/Pause pilot light flashes, one of the following messages appear on the display and the buzzer sounds a jingle to indicate that the machine is not working:
● problem with the water supply: |
|
«Cannot fill water. Please that the tap is open and then press | » |
●problem with water draining:
«Cannot drain the water. Please check that the filter is clean and then press
»
● door open: |
|
«Please check that the door is closed properly and then press | ». |
Once the problem has been eliminated, press the Start/Pause button to restart the programme. If after all checks, the problem persists, contact your local Service Centre.
Malfunction | Possible cause | Solution |
The washing machine does | ● The door has not been | |
not start: | closed. (Please check that | |
| the door is closed properly | |
| and then press | ). |
● The plug is not properly inserted in the power socket.
● There is no power at the socket.
● The main fuse has blown.
● The selector dial is not correctly positioned and the Start/Pause button has not been depressed.
● The «Delay Start» has been selected.
The machine fills then | ● The end of the drain hose is |
empties immediately: | too low. |
●Close firmly the door.
●Insert the plug into the power socket.
●Please check your domestic electrical installation.
●Replace the fuse.
●Please turn the selector dial and press the Start/Pause button again.
●If the laundry are to be washed immediately, cancel the delay start.
●Refer to relevant paragraph in “water drainage” section.