Use 13
Measure out the detergent and the fabric softener
Your new appliance was designed to reduce water, energy and detergent consumption.
1.Pull out the dispenser drawer until it stops. Measure out the amount of
detergent required, pour it into the main
wash compartment 
and, if you wish to carry out the prewash phase or to perform the stain function, pour the detergent or the stain remover into the compartment marked 
.
2.If required, pour fabric softener into the
compartment marked 
(the amount used must not exceed the MAX mark in
the drawer). Close the drawer gently.
Select the required programme
You can choose the right programme for any type of laundry following the descriptions on the washing programme tables (see Washing Programmes).
Turn the programme selector dial to the required programme. The programme selector determines the type of washing cycle (e.g. water level, drum movement, number of rinses) and the washing temperature according to the type of laundry.
Kalt/Froid = Cold wash.
The light of button 7 starts to flash and the display shows the duration of the selected programme.
The selector dial can be turned either clockwise or anticlockwise. Position «O» (Aus Arrêt) to Reset programme/ Switching OFF of the machine.
At the end of the programme the selector dial must be turned to position «O» (Aus Arrêt), to switch the machine off.
Attention!
If you turn the programme selector dial to another programme when the machine is working, the yellow pilot light of button 7 will flash 3 times to indicate a wrong selection. The machine will not perform the new selected programme.