If something goes wrong, ‘The Dryer is

If something goes wrong

	First, don’t panic! There may be nothing wrong at all. Look for your
	problem below, then check the things we suggest. More often than
	not, this will give you the answer to your problem, and you’ll be able
	to carry on without having to telephone your Service Office.
	If after this you still cannot get your machine to work, follow the
	advice given on the next page.
Problem	Check these things first

‘It won’t start’ 1. Is the machine plugged in and switched on at the socket?

2.Is the Control set to required programme?

3.Is the door securely closed?

4.Have you pressed the START button?

5.Has the fuse blown? (Try plugging in another appliance to check).

6.Have you used an extension lead? Many are not suitable. Try plugging the dryer directly into a socket to check.

1.Have you forgotten to clean the filter? It should be cleaned after each load.

2.Does the water container need emptying? Is the Indicator lamp glowing red / orange? The bottle should be emptied after every load.

3.Does the Condenser need cleaning? It should be cleaned every month.

4.Have you selected the correct programme setting for the type of fabric you are drying?

5.Have the air intake grille or rear vents of the Dryer been obstructed?

6.Were the clothes ‘excessively wet’ when they were put in?

7.Was the correct programme selected?

8.Have you overloaded the dryer?

	‘The Dryer is	This is perfectly normal - it means that the Dryer is on ‘Crease Care’
	tumbling	and has reached the end of the drying cycle and the clothes are
	occasionally’	ready to take out.

	‘The dryer keeps	This is perfectly normal, the dryer is on ‘Crease Care’ as above.
	bleeping’	Press the Alarm (Buzzer) button and the bleeping will stop.

	Indicator Lamp is	See section "The Controls", this indicates a possible fault.
	flashing

	Any other	Have you re-read this instruction book?
	problem