Indesit G85C manual Indicator Lamp, Cool Tumble, Phase, Re-start the programme. See previous

Page 10

The Controls

Indicator Lamp

The indicator lamp turns orange during a drying programme when

 

the water container is full. When this happens, you must empty the

 

water container. The programme goes directly to the cooling phase

 

and the dryer stops. The orange light warns you that the load will not

 

be dried correctly. Empty the water container and start the

 

programme again by pressing the start button.

 

At the end of the drying programme if the water container has filled

 

the indicator lamp will glow red. A programme cannot be started

 

when the lamp is red.

 

The indicator lamp goes off (or turns green if a programme is

 

running) a few seconds after the empty water container has been put

 

back.

 

 

If this light flashes it shows that an automatic programme has

 

exceeded 180 minutes. For safety reasons this being the maximum

 

drying time available.

 

Should this occur, the causes may be:

 

The load is too big, or bulky.

 

The filter is blocked.

 

A cotton load was spun at LOW speed.

 

There may be a fault.

 

Turn the dryer Off, check through the first three causes, and then try

 

again.

Cool Tumble

About 10 minutes before the programme is completed, the heating

phase

elements will be switched off, and the programme enters the final

 

‘Cool Drying’ phase. During this phase, the fabric is cooled. You

 

should always allow the dryer to complete this phase.

 

By opening the door, you can check the dryness of the load as often

 

as you wish and if you want remove some items before they are fully

 

dry. (This is particularly useful for a mixed load where you want to iron

 

some items, but others to be fully dried.)

 

You will need to press the START button after closing the door to

 

re-start the programme. See previous page.

Crease Care

At the end of the drying programme it may not be convenient to take

phase

out the clothes immediately. Do not worry, the dryer will protect your

 

clothes from creasing by gently turning them over occasionally by

 

means of a few revolutions of the drum. At the same time, if you have

 

not cancelled the Alarm (Buzzer) a warning buzz will sound

 

intermittently to remind you that the clothes are ready to take out.

10

Image 10
Contents Tumble dryer Contents For your safety Always Refer to the Rating Plate for Voltage and Current Electrical RequirementsQualified Electrician Features Get to know the main parts of your dryer Clean After Each LoadWhere to put your dryer Door Reversal InstructionsHow to use your dryer Removing ItemsControls Timed Programmes for load sizes less than 1kgCool Tumble Indicator LampPhase Re-start the programme. See previousWhen to use ‘Easy Iron’ Audio Signal Easy Iron ProgrammeSorting your laundry Maximum load size Typical loadWash Care Labels Items not suitable for tumble dryingItems requiring special attention Conditioner be Added to the Dryer ItselfEmptying the Water Container ContainerReturn them to the dryer Guide to drying timesRoom Longer to dry than if the room is warm Bulky items There are However Some Items That WE do not AdviseEvery Month Caring for your DryerEvery Week Do not use‘It is taking a long time to dry’ Problem Check these things firstIf something goes wrong ‘The Dryer isIf it still won’t work Printed by Simlex . Four ASHES, Wolverhampton