Whirlpool W10096987A, W10097001A-SP Remove screws from door Attach door hinges, Rotate outer door

Page 18

5. Remove screws from door

8. Attach door hinges

Remove screws at top, bottom, and side of door

(4 screws). Keep door screws separate from hinge screws as they are diferent sizes. Holding door over towel on dryer, grasp sides of outer door and lift to separate it from inner door.

NOTE: Do not pry apart with putty knife or screwdriver. Do not pull on door seal or plastic door catches.

6. Rotate outer door

Reattach door hinges to dryer door so that the larger hole is at the bottom of the hinge.

9. Remove door strike

Take outer door and rotate in 180º and set it back down on inner door. Be certain to keep cardboard spacer centered between doors. Reattach outer door panel to inner door panel so handle is on the side where hinges were just removed. Insert 4 door screws.

7. Flip door over

Remove door strike from dryer cabinet and set aside.

Flip door over so handle side is down.

18

Image 18
Contents Table of Contents Tools and Parts Tools neededParts supplied all models Installation clearancesLocation Requirements Parts neededMinimum Required Spacing Minimum spacing for recessed area or closet installationElectrical Requirements It is your responsibilityScrew in leveling legs Install Leveling LegsPrepare dryer for leveling legs If your outlet looks like thisChoose electrical connection type Wire direct connection Go to stepsElectrical Connection Remove terminal block coverPower Supply Cord Connection Wire Power Supply Cord ConnectionConnect neutral wire Connect ground wireConnect remaining wires Remove center screwDirect Wire Connection Wire Direct Wire ConnectionPrepare your 3-wire cable for direct connection Venting RequirementsOptional 3-wire Connection Connect external ground wireExhaust hoods Venting RequirementsRigid metal vent ElbowsPlan Vent System Alternate installations for close clearancesRecommended exhaust installations Venting KitsVent System Chart Long Vent Models Only Install Vent SystemVent System Chart Install exhaust hoodComplete Installation Checklist Connect VentLevel Dryer Remove bottom screws Reverse Door Swing OptionalPlace towel on dryer Lift door off top screwsCheck door strike alignment Remove screws from hingesSuper Wide Side-Swing Door Remove door strike Remove screws from door Attach door hingesRotate outer door Flip door overTroubleshooting Insert screws in hinge holes on dryer cabinetW10096987A W10097001A-SP