| If using a power supply cord: | ||
| Use a UL listed power supply cord kit marked for use with | ||
| clothes dryers. The kit should contain: | ||
| ■■ | A UL listed | |
|
| minimum. The cord should be type SRD or SRDT and be | |
|
| at least 4 ft. (1.22 m) long. The wires that connect to the | |
1/4" nut driver | Vent clamps | dryer must end in ring terminals or spade terminals with | |
upturned ends. | |||
(recommended) |
| ||
■■ | A UL listed strain relief. | ||
| |||
Adjustable wrench that opens to 1" (25 mm) or
Utility knife
Location Requirements
Tape measure
Level
Pliers |
Caulking gun and compound (for installing new exhaust vent)
You will need:
■■ | A location allowing for proper exhaust installation. |
| See “Venting Requirements.” |
■■ A separate 30 amp circuit. | |
■■ | If you are using power supply cord, a grounded electrical |
| outlet located within 2 ft. (610 mm) of either side of dryer. |
| See “Electrical Requirements.” |
■■ | A sturdy floor to support the total weight (dryer and load) |
| of 200 lbs. (90.7 kg). The combined weight of a companion |
Parts supplied (all models):
Leveling legs (4)
Parts package is located in dryer drum. Check that all parts are included.
Parts needed:
Check local codes. Check existing electrical supply and venting, and read “Electrical Requirements” and “Venting Requirements” before purchasing parts.
Mobile home installations require metal exhaust system hardware, available for purchase from the dealer from whom you purchased your dryer. For further information, please reference the “Assistance or Service” section of the Dryer
User Instructions.
appliance should also be considered. |
■■ Level floor with maximum slope of 1" (25 mm) under entire |
dryer. (If slope is greater than 1" [25 mm], install Extended |
Dryer Feet Kit, Part Number 279810.) If not level, clothes |
may not tumble properly and automatic sensor cycles may |
not operate correctly. |
Do not operate your dryer at temperatures below 45°F (7°C). At lower temperatures, the dryer might not shut off at the end of an automatic cycle. Drying times can be extended.
The dryer must not be installed or stored in an area where it will be exposed to water and/or weather.
Check code requirements. Some codes limit, or do not permit, installation of the dryer in garages, closets, mobile homes, or sleeping quarters. Contact your local building inspector.
Installation clearances:
The location must be large enough to allow the dryer door to open fully.
3