Whirlpool W10096987A, W10097001A-SP installation instructions Tools and Parts, Tools needed

Page 2

DRYER SAFETY

Your safety and the safety of others are very important.

We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages.

This is the safety alert symbol.

This symbol alerts you to potential hazards that can kill or hurt you and others.

All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.”

These words mean:

DANGER WARNING

You can be killed or seriously injured if you don't immediately follow instructions.

You can be killed or seriously injured if you don't follow instructions.

All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed.

INSTALLATION REQUIREMENTS

Tools and Parts

Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.

Tools needed:

 

 

 

 

 

 

 

Flat-blade screwdriver

 

#2 Phillips screwdriver

 

Wire stripper

Tin snips

 

 

 

 

(direct wire installations)

(new vent installations)

2

Image 2
Contents Table of Contents Tools and Parts Tools neededParts supplied all models Installation clearancesLocation Requirements Parts neededMinimum Required Spacing Minimum spacing for recessed area or closet installationElectrical Requirements It is your responsibilityScrew in leveling legs Install Leveling LegsPrepare dryer for leveling legs If your outlet looks like thisChoose electrical connection type Wire direct connection Go to stepsElectrical Connection Remove terminal block coverPower Supply Cord Connection Wire Power Supply Cord ConnectionConnect neutral wire Connect ground wireConnect remaining wires Remove center screwDirect Wire Connection Wire Direct Wire ConnectionPrepare your 3-wire cable for direct connection Venting RequirementsOptional 3-wire Connection Connect external ground wireExhaust hoods Venting RequirementsRigid metal vent ElbowsPlan Vent System Alternate installations for close clearancesRecommended exhaust installations Venting KitsVent System Chart Long Vent Models Only Install Vent SystemVent System Chart Install exhaust hoodLevel Dryer Complete Installation ChecklistConnect Vent Remove bottom screws Reverse Door Swing OptionalPlace towel on dryer Lift door off top screwsSuper Wide Side-Swing Door Check door strike alignmentRemove screws from hinges Remove door strike Remove screws from door Attach door hingesRotate outer door Flip door overTroubleshooting Insert screws in hinge holes on dryer cabinetW10096987A W10097001A-SP