Timed Dry |
| End of Cycle Signal |
Use this cycle to get up to 60 minutes of heated drying time or to complete drying if items are still damp after the automatic cycle. Timed Dry is also useful for:
■Heavyweight items and work clothes that require a long drying time.
■Lightweight items, such as lingerie, blouses and knits that require a short drying time.
See following table for recommended cycles and temperature settings.
Fabric Type | Time | Temperature |
| (minutes) | Setting |
|
|
|
Heavy cottons and denims | 60 | Normal |
|
|
|
Cottons and linens | 40 | Normal |
|
|
|
White and colorfast | 40 | Low |
permanent press |
|
|
|
|
|
White and colorfast items | 40 | Low |
that require ironing |
|
|
|
|
|
Polyester/acrylic blends, | 40 | Low |
rayon, acetate |
|
|
|
|
|
Washable silk and nylon | 40 | Low |
The dryer sounds a signal to let you know when the cycle is finished. The signal is not adjustable and cannot be turned off. The signal is helpful when you are drying permanent press, synthetics, and other items that should be taken out as soon as the dryer stops.
Anti-Wrinkle
During
TemperatureControl
Temperature Control Button
The Temperature Control button lets you select between a normal and low drying temperature.
NOTE: Always refer to the care label on the garment to determine whether it can be tumble dried.
Normal
The Normal temperature setting is for sturdy fabrics, such as cotton, linen and denim. If the Temperature Control button is not pressed in, the temperature setting is Normal.
Low
The Low setting is for synthetics, such as cotton/polyester blend, rayon, acetate, washable silk or nylon. If the Temperature Control button is pressed in, the temperature setting is Low.
DRYER CARE
CleaningtheDryer Location
Keep dryer area clear and free from items that would obstruct the flow of combustion and ventilation air.
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as gasoline, away from dryer.
Place dryer at least 18 inches (46 cm) above the floor for a garage installation.
Failure to do so can result in death, explosion, or fire.
CleaningtheLintScreen
Every load cleaning
The lint screen is located in the door opening of the dryer. Clean it before each load. A screen blocked by lint can increase drying time.
To clean
1.Open the door and pull the lint screen straight up.
2.Open lint screen.
3.Roll lint off the screen with your fingers. Do not rinse or wash screen to remove lint. Wet lint is hard to remove.
4.Close lint screen. Push the lint screen firmly back into place and close the door.
15