8.USE EYE PROTECTION. Solvents can cause serious eye damage . Wear ANSI approved chemical splash safety goggles. Goggles are available from Harbor Freight Tools. When cleaning, be especially careful as solvents can be forcibly ejected from fluid and air passages.
9.DRESS SAFELY. Protective gloves and nonskid footwear or safety shoes must be used when working with and operating the Parts Washer. Don’t wear loose clothing or jewelry. They can get caught in moving parts. Also, wear a protective hair covering to prevent long hair from getting caught in the Parts Washer.
10.DON’T OVERREACH. Keep proper footing and balance at all times.
11.STAY ALERT. Watch what you are doing. Use common sense. Do not operate any tool when you are tired.
12.CHECK DAMAGED PARTS. Before using any tool, any part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment of moving parts, breakage of parts, and other conditions that may affect its operation.
13.REPLACEMENT PARTS AND ACCESSORIES. When servicing, use only identical replacement parts. Only use accessories intended for use with this Parts Washer. Approved accessories are available from Harbor Freight Tools.
14.STORE IDLE EQUIPMENT. When not in use, the Parts Washer should be cleaned and then stored, fully assembled, in a dry location to reduce rust. For safety, keep out of reach of children.
15.MAINTAIN TOOLS WITH CARE. Keep tools clean for better and safer performance. Follow instructions for lubricating, cleaning and changing accessories. Keep handles dry, clean and free from oil and grease.
16.OUTDOOR EXTENSION CORDS. When the Parts Washer is used outdoors, use only rounded jacket extensions cords intended for outside use. See manufacturer’s manual for the AWG required for the compressor’s amperage draw. Do not leave the Parts Washer outside for extended periods of time.
17.DO NOT MODIFY OR JAM LID TO KEEP LOCKED IN AN OPEN POSITION. The lid is on a fusible link and is designed to fall automatically to extinguish flames. If fire should occur, do not attempt to move parts washer.
GROUNDING INSTRUCTIONS
1.This machine has a three prong plug. The third prong (round) is the ground. Plug the machine’s cord only into
2.If a
SKU 35740 | For technical questions, please call | Page 3 |