Miele W 1215 installation instructions Plumbing, Hose extension optional accessory

Page 51

Plumbing

The washing machine can be connected to a portable water supply. A non-return valve is not needed unless required by building code.

The washing machine has ½" (13 mm) pressure hoses with 3/4" (19 mm) female hose thread connections. If there is no water hookup, contact a plumber to install a connection. Make sure that the sealing ring is seated properly on the hose connector.

Replace the hose only with a genuine Miele hose, or with a hose able to withstand up to 145 psi (10 bar) pressure. The water valve connector must also be able to withstand 145 psi (10 bar).

,The bolted connection is under water pressure. Open the water supply slowly to check for leaks. Adjust the rubber seal and the bolted connection if necessary.

To protect the inlet valve, the two filters (one at the pressure hose / valve connection and one at the inlet connection to the solenoid valve) must not be removed.

Hose extension (optional accessory)

Hose extensions with a length of

8’ 2 7/16" to 13’ 1 ½" (2.5 to 4 m) are available from your Miele dealer or

Miele.

47

Image 51
Contents Operating and Installation Instructions Washer 1215 Contents Plumbing Important Safety Instructions Control panel Guide to the washerBefore using for the first time Using the washer Prepare and sort the laundryGeneral tips Close the drum door Load the laundry Select a programProgram guide Handwash Temperatures Fabric Spin Laundry Care Speed Symbol WoolensCold Med SilkSelect wash options if needed Select the temperature and spin speed To finish the program Special spin options HoldNo spin To start the final spinAdd detergent Too little detergent may causeToo much detergent may cause Liquid detergent insert DetergentNormal soiling DetergentWater hardness Water softenerFabric softener Do not exceed the maximum fill level Starch Fabric dyeActivate the program lock if necessary Select Delay Start if neededCanceling Delay Start Start the programRemove the laundry Canceling a program Making changes to the programInterrupting a program Drum door cannot be opened if Adding / removing laundry during a wash programLocking the washer Electronic program lock Child Safety LockDesclaing the washer Cleaning and CareCleaning the washer Cleaning the drumCleaning the detergent drawer Open the access panel Cleaning the drain pump and lint trapRemove this guide for easy reference Quick GuideSelect a program Quick GuideSort the laundry Load the laundryStart the program Select the temperature and spin speedSelect Delay Start if needed Add detergentNormal Options Cleaning and Care Cleaning the water inlet filters Cleaning the inlet hose filterCleaning the filter in the inlet valve Changing the light bulb Wash program cannot be started Frequently asked questionsProgram was interrupted and a fault message appears General issues with the washer Poor wash results Door will not open when the Door button is pressed Open the lint trap door Opening the drum door during a power failureRepairs After sales servicePC Update Optional accessoriesInstallation Instructions Help protect our environment Disposal of the packing materialDisposal of an appliance Front view InstallationBack view Do not lift the washer by the drum door Installation siteInstallation Removing the shipping strutsPull out the shipping strut InstallationInstalling the shipping struts Level the washer Adjust the four leveling feetInstallation beneath a counter Washer stand with drawer Washer / Dryer Stack Reinstallation of the machine lidPlumbing Hose extension optional accessoryWater connection Do not connect the washer to hot water onlyTips for a hot water connection Drainage Electrical Instructions Electrical connection
Related manuals
Manual 56 pages 3.96 Kb