BEFORE USE
MPlease read all of the instructions for use and the Important Safeguards carefully.
MRemove all packaging from the generator.
MIt is normal for a small amount of smoke and a light odor to be produced the first time it is used. This will quickly disappear.
HELPFUL HINTS
MBefore using the generator for the first time or if you have not used the steam function for a few minutes, press the steam button several times in a row while holding the iron away from your clothes. This will enable any cold water to be removed from the steam connection cord.
MWhen ironing start with fabrics that require a low temperature setting (●) and finish with those which need the highest temperature (● ● ●).
MMixed fiber fabrics should be ironed on the temperature for the most delicate fabric. For example a shirt that is 60% cotton and 40% polyester should be ironed at the (●) setting for synthetics.
MIf spray starch is used, spray it onto the reverse side of the garment. Allow starch to penetrate before ironing.
MFor best results, use a mesh type ironing board to allow excess steam to escape.
MFor delicate fabrics, we recommend carrying out a test on an unobtrusive area of the garment such as an inner seam.
FILLING THE BOILER
The steam generator is designed to operate using tap water. Please review Water Recommendations section for additional water information.
1. While unplugged, place the steam generator on a stable,
horizontal, heat resistant surface.
2. Unscrew the boiler cap.
3. Using a water pitcher, fill with 33oz. of water. Do not fill water tank past the base of the boiler cap thread. Do not overfill. Be sure that water does not spill over. If this occurs remove the excess water.
4.Replace the boiler cap and screw it on tightly.
To fill boiler while you are using the appliance see section
Filling Boiler While In Use.
TURNING ON AND OFF:
(A)
1.Plug the generator into a 120 volt electric outlet.
1.DG560 model: Press the on/off switch (A) on the control panel and the steam indicator light will turn on. Adjust the temperature control dial on the iron to heat the soleplate. The temperature indicator light will light up on the iron.