Problem with the dispenser…
Not all the detergent has been flushed away.
1.Check the water supply tap is fully turned on.
2.Check the inlet hose is not kinked.
The dispenser drawer will not close properly.
1.Check the drawer is aligned properly
2.Check the drawer is not clogged with detergent (see Care and Maintenance)
Steam is coming from the dispenser. The machine is designed to vent through the drawer, this is nothing to worry about.
The clothes load is not dry…_
Was sufficient time or automatic setting selected to dry the clothes load? (Refer to Drying Time Guide page 35.)
Is the wash programme selected followed automatically by a drying programme? (Refer to Programme Guide page 26.)
Was the laundry correctly spun prior to drying? Select a spin programme to remove the excess water.
Has the correct drying programme been selected? Refer to the laundry care label for guidance.
The laundry may have been excessively wet at the end of the wash cycle eg. The load was out of balance (see page 22). In this case the load may not have dried within the maximum time allowed. Select a drying only programme (page 25) to complete the drying.
Error 9 is displayed…
Cancel the programme by returning the selector to the OFF position.
Wait
Remember, you may be charged for the service call if incorrect installation or misuse causes a problem with your machine.
If the following error codes are displayed, switch OFF the machine and contact Hoover Service: 0, 1, 4, 5, 7 and 8.
Note: The use of environmentally friendly,
Waste water from rinsing may be cloudier because of the presence of a white powder (zeolites) held in suspension, without the rinse performance being adversely affected.
Presence of white powder on laundry after washing, which is not absorbed by the fabric and does not alter the colour of the fabric.
The presence of foam in the final rinsing water is not necessarily an indication of poor rinsing. Carrying out more rinse cycles does not serve any purpose in such cases.
40