Hoover WDYN D8P manual Connecting the Cold Water Supply

Page 11

Connecting the Cold Water

Supply

Only one hose is required to install this machine to a cold water supply. Cold ﬁll is an energy efﬁcient system. Only the water required to wash the laundry is heated. There is no loss of heat in the pipeline from the hot water tank or the boiler.

If your previous machine installation was hot and cold ﬁll ensure that the hot tap is ﬁrmly closed to prevent leakage.

This machine has an inlet hose with a 19mm (3/4") threaded ferrule ﬁtted to the end, to attach between the threaded connector on the appliance and the water supply. Only use the new hose supplied to connect the machine and ensure that the sealing washers are in place inside the hose connectors.

Do not re-use old hoses that are attached to existing installations.

Do not over-tighten the connections. Hand tight is sufﬁcient.

Do not trap or kink the hose.

Step 1. Connect the elbow end of the hose provided to the threaded inlet on the back of the machine.

The grey pipe needs to connect to the white threaded inlet on the machine.

Step 2. Hand tighten the connector.

Step 3. Connect the straight ends of the pipes to the water supply; ensure that there are no kinks.

Step 4. Turn on the water supply and check there are no leaks. If there is a leak, turn off the water supply, disconnect the hose and check the sealing washers are in place. Reﬁt the hose and turn on the water supply.

11

Image 11

Contents Instruction Book Contents Delivery information GuaranteeIntroduction Technical data Customer ServiceEuropean Directive 2002/96/EC Caring for the environmentInstructions Page Unpacking the Product Electricity Supply InstallationWater Supply Connecting the Cold Water Supply Connecting the drainage pipe Levelling The Machine Testing the InstallationPage Description of the Machine Start Pause Button Cancelling and Changing the ProgrammeControl Panel Turning the Machine OnSpin Speed Wash TemperatureDoor Locked indicator Digital DisplayWash Length Indicator Delay StartKG Mode Indicator Drying Programme IndicatorsSensitive Care TemperatureWash Options Night & DayWash Time Selector DRY Options Pulse Technology Automatic FeaturesKG Mode Half Load Out of Balance protectionSynthetics Programme DescriptionsCotton with Pre Wash ColouredsWool & Silk DelicateRapid SportsAll Baby High DryLow Dry Wash & Dry 59’Programme Programme GuideLength of Programme Detergent Items to avoid LaundryDispensing instructions Dispensing in the drumWashing Advice Running a Wash Cycle When the programme has ﬁnished Sort the load before drying Drying AdviceItems to avoid when drying Starting the drying cycle Running a Dry CycleSorting the laundry Selecting the drying programmeEstimated drying times of Sensor Dry programmes Cleaning the ﬁlter Care and MaintenanceCleaning the soap dispenser Cleaning the door glassMaintenance wash Machine will not start… Problem Solving GuideWater does not drain away… error 3 will be displayed Defects you can remedy yourselfProgramme takes a long time… Water on the ﬂoor around the washing machineMachine does not spin… Machine is noisy or vibrates a lot during the cycle…Clothes load is not dry… Problem with the dispenser…Error 9 is displayed… Power Failure 08444 After Sales ServiceCustomer Service GuaranteeBrochures Guarantee excludesSpares and Accessories 01204 556Page Page Page Page EnItalie enItalie