Filling Water Reservoir with Water

USING THE

FABRIC STEAMER & IRON

NOTE: When water level is low, it is normal for water reservoir in Base Unit to emit a pumping sound. Adding more water will eliminate the sound.

CAUTION: Be sure that power cord is not connected to an electrical outlet before filling water reservoir with water.

1.Unscrew Water Reservoir Cap by turning it in a counter-clockwise direction (FIGURE 4-A). This will expose the Water Reservoir Inlet.

2.Fill included Measuring Cup with water, then pour into water reservoir through Inlet.

NOTE: In order to prolong the life of your Fabric Steamer & Iron, it is recommended that de-mineralized or distilled water is used to avoid mineral build-up.

3.Repeat STEP 2 above, in order to completely fill water reservoir with 32 oz. (950 ml.) of water.

IMPORTANT: Do not add detergents or other chemicals to water reservoir; doing so may result in damage to the unit.

4.Place Water Reservoir Cap back onto Water Reservoir Inlet, and rotate it in a clockwise direction to secure it back into place (FIGURE 4-B).

FIGURE 4

10	Top Innovations, Inc.

ASSEMBLING THE

FABRIC STEAMER & IRON

SECURING WALL-MOUNTING BASE TO WALL

CAUTION: Be sure Wall-Mounting Base is located where small children will not have access to the unit’s cords when it is mounted.

1.Select a location for Wall-Mounting Base. Be sure that Base will not prevent a door from opening or closing properly, and that cords will not get closed in a door.

CAUTION: In order to avoid electrical shock, do not hang unit directly over an electrical outlet.

2.Refer to FIGURE 1 below, which illustrates how to use included screws and anchors to secure Wall-Mounting Base to wall.

NOTE: Keep in mind that the Fabric Steamer & Iron may be used while mounted on the Wall-Mounting Base. Alternatively, the Base Unit may be removed and used on any ordinary table top or other flat surface, and mounted on the Wall- Mounting Base for storage purposes only.

Mount between 36” (91cm) and 54” (137cm) from floor.

FIGURE 1

Top Innovations, Inc.