Top Innovations SF-432 Mounting Base Unit Onto WALL-MOUNTING Base, Connecting the Fabric Brush

ASSEMBLING THE

FABRIC STEAMER & IRON

MOUNTING BASE UNIT ONTO WALL-MOUNTING BASE

1.Hang Steam Nozzle securely onto Steam Nozzle Hanger (FIGURE 2-A).

2.Align two holes on back of Water Reservoir with two hooks protruding from front of Wall-Mounting Base. Press Water Reservoir onto Wall-Mounting Base. Once pressed together, slide Water Reservoir down to secure it onto Wall-Mounting Base (FIGURE 2-B).

NOTE: To keep the power cord stored away when not in use, cord may be wrapped around the Water Reservoir while Base Unit is mounted on the Wall-Mounting Base.

A

B

FIGURE 2

ASSEMBLING THE

FABRIC STEAMER & IRON

CONNECTING THE FABRIC BRUSH

CAUTION: Use care when connecting Fabric Brush, as Ironing Plate may be hot. Do not attempt to connect Fabric Brush while unit is emitting steam.

1.Slide Fabric Brush onto Steam Nozzle, over Ironing Plate as shown (FIGURE 3). Press down until hook on bottom of Brush (FIGURE 3-A) catches onto tab below Plate (FIGURE 3-B). Fabric Brush should now be secured in place.

2.In order to remove Fabric Brush, pull outward on hook until it slides upward over tab. Pull upward on Brush to slide it over Ironing Plate and off of Steam Nozzle.

A

B

FIGURE 3

8 Top Innovations, Inc. Top Innovations, Inc. 9