Russell Hobbs RH1261TW instruction manual Levelling the machine, Electrical connection

Page 8

Levelling the machine

Your machine should be installed on a hard surface – do not install onto a carpet.

For your machine to work quietly and without any vibration, it should it be settled on a flat, non-slippery and tough ground.

Loosen the plastic adjustment nut.

Adjust the feet upward and downward by rotating them clockwise and anti clockwise.

When the correct balance has been achieved, tighten the plastic adjustment nut again by rotating it upwards.

Never put cardboard, wood or other materials under your machine to try and stabilise the unit.

Electrical connection

Your washing machine is set to 220-240V and 50Hz.

The mains cord of your washing machine is equipped with a specific grounded plug. This plug should always be inserted to a grounded socket of 13 amps. The current value of the fuse should be 10 amps.

We do not take responsibility for any damage that occurs due to ungrounded usage.

Operating your machine under low voltage will cause the life cycle of your machine to be reduced and its performance to be restricted.

For Customer Services, Spare Parts & Manufacturer's Warranty Information please call 01204 664 084 -8-

Image 8
Contents Washing Machine 01204 664Contents Error Messages Energy Efficiency Safety Warnings Before UseRecommendations Back ComponentsFront Installation Removing transportation boltsLevelling the machine Electrical connectionWater discharge connection Only a qualified engineer should install this machineWater inlet connection Technical specifications Preparing your laundry Using your machine DetergentControl Panel Detergent DrawerSelecting a Programme Electronic DisplayBefore Use First WashAdditional Functions Half Load DetectionTwinjet system Temperature C Programme selectionAdditional Functions Spin SpeedTemperature selection Pre WashEasy Iron Delay TimerRapid Wash Anti-Allergy Function Start/Pause buttonAdding/Removing Laundry Child LockFinishing programme Cancelling a ProgrammeProgramme End Water cut off / Low Mains Pressure Blocked pump filterMaintenance and Cleaning Water Inlet FiltersCleaning the pump Cleaning the detergent drawer Cleaning your machine∙ Do not wash your detergent drawer in a dishwasher Drawer filterDrum Trouble ShootingBody Fault Possible Cause Removing Methods Error Messages Tap may be off Energy Efficiency BL6 9AJ