EN
4.15 PROGRAMME END
Washing programmes are completed automatically. The word END appears on the display and the "Time remain- ing" light goes out.
1.Switch the appliance off by turning the programmes knob to OFF
2.Unload the laundry from the drum.
3.Leave the door ajar to allow the interior of the washing machine to dry out.
4.Turn off the water intake tap.
If during the initial spin speed setting stage, the "no spin" mode with stop with tank full (spin speed set as
0)was selected, at the end of the washing programme the word STOP appears on the display, alternating with
(spin speed of 0) and the spin light is on.
To proceed with the
4.16CHILD LOCK
1.When this function is activated, the modification of options, temperatures, spin speed and the wash- ing/drying cycle is not possible while the cycle is in progress.
Child Lock Symbol
2
1
2.To activate the Child Lock Function, press the Child Lock (1) button and hold it down. Also press the Op- tions selection (2) button within 3 seconds.
3.The Child Safety Function symbol lights up to show that the function has been activated.
4.Repeat the same procedure to deactivate the function.
4.17OPENING THE APPLIANCE IN AN EMERGENCY
In the event of a power failure, the door is opened using the mechanical release device activated by means of the lever in the bottom of the appliance:
•Turn the knob to Off and disconnect the power supply plug from the socket.
•Drain off the water (see point 5.4)
•Pull the lever down and open the door.
Warning, scolding hazard: before opening the door, check that the appliance does not contain boiling hot water and de- tergent which may pour out and cause injury when the door is opened.
Warning: do not open the door using the emergency release lever while the drum is turning.
14