Ariston AW 125 important safety instructions Inches, 62 86 cm

Installation

NA

Floor Standpipe Drain

Sink Drainpipe Method

(A)

25"-34" inches

62 - 86 cm

Top of standpipe must be at least 25 inches (62 cm) high and no higher than 34 inches (86 cm) from the bottom of the washer (A).

Entry into the sink drain system must be above the trap (see fig. aside ).

When routing the drain hose through cabinets or

walls use aprotective

material such as

electrical duct tape to

cover sharp edges that

could damage the drain

hose. Use a suitable clamp to secure the drain hose to the “Y” branch or

the disposer. With a sink drainpipe system (see figures aside and below), you may connect directly:

25”

34”

Wall Standpipe Drain

Top of standpipe must be at least 25 inches (62 cm) min.; 34 inches (86 cm) max from end of drain hose to bottom of washer (B) (See figures aside and below).

#^

1)to a disposer by following the manufacturers attachement method.

2)directly to a “Y” branch tail piece (Available at most hardware stores).

3)through the floor to a separate trap. The trap must be vented to prevent siphoning. To provide proper venting , install an Air Gap Kit (available at most hardware stores).

4)To the faucet using a Faucet Adapter Kit (available separately). It will supply water from your faucet and discharge water directly into your sink drain.

Under Sink Method

1. Cut the blocked end of the under sink drainage unit.

	2. Fix the hooked end
	supporta minimum of
	620 mm from the floor.
H o s e	3. Use a hose clip clamp
	to securely attach the
clamp
	grey drainage hose
620 mm	end to the under sink
	drainage unit using a
	hose. clamp

8 www.aristonappliances.us