18Use
Select an additional rinse
This appliance is designed for saving water. However, for people with a very delicate skin (allergic to detergents) it may be necessary to rinse the laundry using an extra quantity of water (extra rinse).
1200
900
700
500
PRE- CENTRIFUG. LAVADO
SOBRE DOSIF. 
AQUACARE
START/PAUSA
Press simultaneously the Spin Speed and
Prewash buttons for some seconds: the
Extra Rinse pilot light comes on in the programme progress display. This func- tion stays permanently on. To remove it press the same buttons again until the Extra Rinse light goes off.
Altering an option or a running programme
It is possible to change any option before the programme carries it out. Before you make any change, you must pause the washing machine by pressing the Start/Pause button.
Changing a running programme is possible only by resetting it. Turn the programme selector dial to O and then to the new programme position. The washing water in the tub will not emptied out. Start the new programme by depressing the Start/Pause button again.
Interrupting a programme
Depress the Start/Pause button to interrupt a programme which is running, the corresponding light starts to flash. Depress the button again to restart the programme.
Cancelling a programme
Turn the selector dial to O to cancel a programme which is running. Now you can select a new programme.
Opening the door after the programme has started
First set the machine to pause by pressing the Start/Pause button.
After some minutes goes off, the door can be opened.
If the door remains locked, this means that the machine is already heating, that the water level is above the bottom edge of the door. In this case the door can not be opened.
If you cannot open the door but you need to open it you have to switch the machine off by turning the selector dial to O. After about some minutes the door can be opened (pay attention to the water level and temperature!).