AEG 62895, 60895 manual Display Tiempo, Programme progress display

Page 14

Description of the appliance

RINSE HOLD (STOP ACLARADO)

By selecting this option, the last rinse water is not emptied out, to prevent the fabrics from creasing. When the programme has finished, the START/PAUSE button goes off, the END pilot light (FIN) on the pro- gramme progress display illuminates, the DOOR light (PUERTA) is red and the display shows a static zero to indicate that the water must be emp- tied out.

To empty out water there are two possibilities:

• Select programme “DESAGUAR” (draining):

The water is emptied out without spinning.

Select programme “CENTRIFUGAR” (SPIN) or “CENTRIF. DELICADO” (DELICATE SPIN). Select the spin speed by means of the relevant button and then depress the START/PAUSE button. The water is emptied out and the laundry is spun at the selected spin speed.

Warning! The programme selector dial must be turned first to RESET O and then to the DRAIN programme “DESAGUAR” or “CENTRIFU- GAR” (SPIN) or “CENTRIF. DELICADO” (DELICATE SPIN).

Display (TIEMPO)

The display shows the following information:

Duration of the selected programme (in minutes), calculated auto- matically on the basis of the maximum recommended load for each type of fabric.

When the programme has finished, a steadily lit zero is displayed.

Delay start, (23 hours max.) programmed using the button PRESE-

LECCIÓN. The countdown is updated every

hour du-

ring the first two hours and then every thirty minutes.

 

Alarm code indicating a fault in the machine operation (see page 78).

Programme progress display

By selecting the wash programme, the pilot lights corresponding to the various phases making up the programme come on.

After the machine has started, only the running phase pilot light stays on. When the programme has finished, the FIN (End) pilot light comes on.

PREWASH/ PRELAVADO/

WASH LAVADO

RINSES ACLARADO

EXTRA ACLARADO RINSE

SPIN CENTRIFUGAR

END

FIN

OVER-

SOBRE DOSIF.

DOSAGE

 

DOOR

PUERTA

When the programme has finished, if the SOBREDOSIFICACION light (Overdosage) comes on, it indicates that too much detergent has been used.

56

Image 14
Contents Lavamat L 60895 Dear customer Contents Programme charts wash and special programmes Page Positioning, connection, starting up Safety instructionsGeneral safety Follow the instructions for positioning and connectionChild safety Proper usePackaging materials DisposalTips for environmental protection MachineMain features of your washing machine Description of the appliance Front viewControl panel Programme selector dialDelay Start button Preselección START/PAUSE button START/PAUSAProgramme Option buttons To be used for heavily soiled laundryDisplay Tiempo Programme progress displayAltering an option which is running Cancelling a programmeAltering a programme which is running Opening the door after the programme has startedDetergent dispenser drawer Before the first washPreparing the wash cycle Sorting out and preparing the laundryTypes of fabric and care labels Weight of laundrySort of laundry Approximate Dry weights CottonDelicates Detergents and additives Add detergent and additives How to washLoad the laundry Select the spin speed or Rinse Hold option Select the desired wash programmeSelect the desired options Select the Delay Start option Selection of the Extra Rinse optionStarting the programme DisplayAt the end of the programme 40-30 Programme chartWash programmes for cottons Wash Temp Fabrics Additional Max Consumption FunctionsKWh Water lt Special programmesConsumption Energy Tion After each wash Cleaning and maintenancePeriodical cleaning Exterior Detergent dispenser drawerDoor seal Drain pumpScrew the pump fully Close the pump door Water inlet filterEmergency emptying out Frost precautions Something not working? TroubleshootingProblem Possible cause Solution Problem Possible cause SolutionProblem Possible cause DistributedFoam is still visible even after the last rinse Unsatisfactory washing resultsIf grey stains remain on the laundry White residue is left on the laundryThis appliance complies with the following EC directives Technical dataWater pressure 05 0.8 MPa Service Instructions for installation and electrical connection Safety instructions for the installerSix smaller bolts C InstallationUnpacking Remove the bracket D. Tighten up the six smaller bolts CPositioning Fill the smallerMPa 0.5 bar is required for safe operation of the appliance LevellingWater inlet Water drainage End of the drain hose can be positioned in three waysConnect the machine to an earthed socket Electrical connectionPermanent connection Page Salvo modificaciones From the Electrolux Group. The world’s No choice