Installation
Levelling
Carefully level by screwing the adjustable feet in or out. Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the floor.
Water inlet
Attention!
•An inlet hose is supplied and can be found inside the machine drum.
•Do not use the hose from your previous machine to connect to the water supply.
• This appliance must be connected to a cold water supply.
1. Open the porthole and extract the inlet hose.
2. Connect the hose with the angled con- nection to the machine.
Important!
HEC0006
Do not place the inlet hose downwards. Angle the hose to the left or right depending on the position of your water tap.
3.Set the hose correctly by loosening the ring nut. After positioning the inlet hose, be sure to tighten the ring nut
again to prevent leaks.
4. Connect the hose to a tap with a 3/4”
thread. Always use the hose supplied with the appli-
ance.
Installation should comply with local water authority and building regulations’ require- ments. A minimum water pressure of 0.05
MPa (0.5 bar) is required for safe operation of the appliance.
If you cannot make the cold water connection direct from the rising mains, you may be able to operate the appliance from your cold water storage system. There should be a minimum distance of 5.02m (16.5 ft) between theappliance’s inlet and the bottom of the water storage tank.
84