AEG 62895 Electrical connection, Permanent connection, Connect the machine to an earthed socket

Page 44

Installation

Electrical connection

This machine is designed to operate on a 220-230 V, single-phase, 50 Hz supply.

Check that your domestic electrical installation can take the maximum load required (2.2 kW), also taking into account any other appliances in use.

Connect the machine to an earthed socket.

The manufacturer does not accept any responsibility for damage or injury through failure to comply with the above safety precaution.

Permanent connection

In the case of a permanent connection it is necessary that you install a double pole switch between the appliance and the electricity supply (mains), with a minimum gap of 3 mm between the switch contacts and of a type suitable for the required load in compliance with the current electrical regulations.

The switch must not break the yellow and green earth cable at any point.

This operation must be performed by a qualified electrician.

Important: The power supply cable must be easily accessible after installing the machine.

86

Image 44

Contents Lavamat L 60895 Dear customer Contents Programme charts wash and special programmes Page Safety instructions General safetyPositioning, connection, starting up Follow the instructions for positioning and connectionChild safety Proper useDisposal Tips for environmental protectionPackaging materials MachineMain features of your washing machine Description of the appliance Front viewControl panel Programme selector dialDelay Start button Preselección START/PAUSE button START/PAUSAProgramme Option buttons To be used for heavily soiled laundryDisplay Tiempo Programme progress displayCancelling a programme Altering a programme which is runningAltering an option which is running Opening the door after the programme has startedDetergent dispenser drawer Before the first washPreparing the wash cycle Sorting out and preparing the laundryWeight of laundry Sort of laundry Approximate Dry weightsTypes of fabric and care labels CottonDelicates Detergents and additives Add detergent and additives How to washLoad the laundry Select the spin speed or Rinse Hold option Select the desired wash programmeSelect the desired options Select the Delay Start option Selection of the Extra Rinse optionStarting the programme DisplayAt the end of the programme 40-30 Programme chartWash programmes for cottons Wash Temp Fabrics Additional Max Consumption FunctionsKWh Water lt Special programmesConsumption Energy Tion Cleaning and maintenance Periodical cleaning ExteriorAfter each wash Detergent dispenser drawerDoor seal Drain pumpScrew the pump fully Close the pump door Water inlet filterEmergency emptying out Frost precautions Something not working? TroubleshootingProblem Possible cause Solution Problem Possible cause SolutionProblem Possible cause DistributedUnsatisfactory washing results If grey stains remain on the laundryFoam is still visible even after the last rinse White residue is left on the laundryThis appliance complies with the following EC directives Technical dataWater pressure 05 0.8 MPa Service Instructions for installation and electrical connection Safety instructions for the installerInstallation UnpackingSix smaller bolts C Remove the bracket D. Tighten up the six smaller bolts CPositioning Fill the smallerMPa 0.5 bar is required for safe operation of the appliance LevellingWater inlet Water drainage End of the drain hose can be positioned in three waysConnect the machine to an earthed socket Electrical connectionPermanent connection Page Salvo modificaciones From the Electrolux Group. The world’s No choice