Technics SC-HD310 Before recording, Preparatory steps, Press REV Mode to select Reverse mode

A

COUNTER

B

Side A

Before recording

Selection of tapes for recording

The unit automatically identifies the type of tape.

Normal position/TYPE 1	✔
High position/ TYPE 2	✔
Metal position/ TYPE 4	✔

ATo display the tape counter while recording

Press [COUNTER].

The counter is displayed for about five seconds.

BErasure prevention

The illustration shows how to remove the tabs to prevent recording. To record on the tape again, cover as shown, being careful not to cover the high position discrimination hole.

Tab for side “B”	Tab for side “A”
	To re-record
Normal tape	Hi-position tape

				Detection hole
C	2	3	1

1 OPEN/CLOSE

2 DOLBY NR

NR

3 REV MODE

NR

Volume and sound quality

Recordings are unaffected by changes to volume and sound quality.

CPreparatory steps

Do these steps before each recording.

Wind up the leader tape so recording can begin immediately (unnecessary if CD editing).

1 Press [				OPEN/CLOSE], insert the
cassette with the tape facing in.					operations
2 Press [DOLBY NR] to select Dolby NR
Make sure the cassette is fully inserted and press
[	OPEN/CLOSE] to close the deck.
on (“			NR” appears) or off.		Recording
(a “Dolby noise reduction” page 14).
3 Press [REV MODE] to select the
reverse mode.
Each time you press the button:
				: One side only records.
		and		: Both sides record (forward → reverse).
				“ ” automatically changes to “	”
				when [● REC PAUSE] is pressed.

Erasing recordings

1.Press [INPUT SELECTOR] to select “TAPE”.

2.Press [DOLBY NR] so that “ NR” goes off.

3.Select the reverse mode.

4.Press [● REC PAUSE].

5.Press [v] or [u].

19

RQT5296