Technics SC-HD310, SC-HD510 manual Basic connections for supplied accessories

Page 7

Basic connections for supplied accessories

ABefore connection

● Do not connect the AC mains lead until all other connections are complete.

● To prepare the AM loop antenna, FM antenna (for Australia and N.Z.) and speaker cables, twist the vinyl tip and pull off (a).

● Disconnect the flat cable on the cassette deck (b).

1 Flat cables.

Keep the cables as flat as possible against the back of the unit.

2 FM antenna.

Fix the other end of the antenna where reception is best.

3 AM loop antenna.

Keep loose antenna cord away from other wires and cords.

4 Speaker cables.

Connect the cables to the terminals of the same color. Never allow the exposed wires to contact each other when connected.

Use only the supplied speakers.

The combination of the system and the front speakers provides the best sound. Using other speakers can damage the unit and sound quality will be negatively affected.

(United Kingdom only)

BE SURE TO READ THE CAUTION FOR THE AC MAINS LEAD ON PAGE 4 BEFORE PROCEEDING TO STEP 5.

5 Connect the AC mains lead.

Insertion of connector

Even when the connector is perfectly inserted, depending on the type of inlet used, the front part of the connector may jut out as shown in the drawing.

However there is no problem using the unit.

Connector

Approx. 6 mm

Appliance inlet

For your reference

Information you enter into the unit’s memory, except for time, remains intact for up to two weeks after the mains lead is disconnected.

Note

The included AC mains lead is for use with this unit only. Do not use it with other equipment.

Before use

7

RQT5296

Page 6 Page 8
Image 7
Page 6 Page 8
Contents SC-HD310 RS-HDA710 System SC-HD510 SC-HD310RAK-HDA26WH RAK-HDA25WH Table of contents Safety precautions Before use How to replace the fuseEB area code model only Use Remote controlInstallation BatteriesSpeaker Amplifier ConnectionsBasic connections for supplied accessories FM outdoor antenna Optional antenna connectionsConnections External unit connectionsTuner Front panel controlsCD player Cassette deckFront panel controls Remote controlTurning the Demo function off AmplifierClock Play REC Setting the timeSaving power in standby mode QPress /I to turn the unit on Press ModePress FM or AM to select the band Radio manual tuningPress Tune Mode to select Manual Adjust the volumePress the numbered buttons to select the channel Radio preset tuningHold down SET Press TunerCassette tapes Press TPS Skip to select Press TPS or TPS while the tape is stoppedCassette tapes Press OPEN/CLOSE to open the tray Press u to start play Adjust the volumeCDs Normal playPress Repeat before or during play Other modes of playSelect the track with the numbered buttons Press RandomProgram play Press sPress OPEN/CLOSE, insert Cassette with the tape facing Press REV Mode to select Reverse modeBefore recording Preparatory stepsRecording CDs Recording the radioNormal recording Linking One touch CD editing AI EditPress AI Edit Recording CDsPress /I to turn the unit off Using the timersPlay timer QPress CLOCK/TIMER, -DEMO to select PlayQPress CLOCK/TIMER, -DEMO to select REC Record timerUsing the timers Press Sleep to select the time minutes Play and record timersSleep timer Using the timers togetherRecording an external source Using other equipmentUsing headphones not included Listening to an external sourceConvenient functions MaintenanceTroubleshooting guide Technical specifications DIN 45
Top Page Image Contents