Run wash cycle
During the washing program
You can at any time
–change the setting of the final spin speed,
–select 
(Rinse Hold),
–change the setting of the temperature.
Other settings cannot be changed.
To stop the washing program prematurely:
0Press the 
(ON/OFF) button.
0Turn the program selector clockwise to 
(PUMP OUT).
0Press the 
(ON/OFF) button again. The water is pumped out.
Washing cycle finished/Removing the washing
The washing program is completed when the | (ON/OFF) button |
display lamp goes out. |
|
After a Rinse Hold the water must first be pumped out or the washing spun:
0Either press the final spin speed/
(Rinse Hold) button so often until the display of the spin speed required lights up,
or
turn the program selector clockwise to 
(SPIN)
(washing is spun in accordance with the program which has just run), or
turn the program selector clockwise to 
(PUMP OUT). (water is pumped out).
0Open the door.
0Remove the washing.
0 Switch off the washing machine by pressing the | (ON/OFF) button. |
0Close the tap.
0Pull the detergent compartment out a little so that it can dry. Only lean the door to so that the washing machine can get some air.
23