AEG 62600 operating instructions Feet are not correctly set Tion instruction

		Troubleshooting
Malfunction	Possible cause	Remedy
	The height-adjustable screw	Adjust the feet according to
		the installation and connec-
	feet are not correctly set.
		tion instruction.
	There is only very little wash-	This does not hinder the
	ing in the machine (e.g. only	machine from functioning
Washing machine	a bath robe).	correctly.
vibrates during opera-
		Check that the outlet hose is
tion or is unsteady.	Water could not be com-
		correctly laid and if applica-
	pletely pumped out before
		ble eliminate the kink or
	the spin because
		clean the suds pump and if
	there is a kink in the outlet
		necessary remove any for-
	hose or the suds pump is
		eign bodies from the pump
	blocked.
		housing.
The suds in the main	Probably too much washing	Only use as much as the
wash cycle create too		washing powder manufac-
	powder was used.
much foam.		turer recommends.
	The clamp on the inlet hose	Tighten the inlet hose.
	is not tight.
	The inlet hose has a leak.	Check the inlet hose and if
Water is leaking out		necessary replace it.
from under the wash-	The lid of the suds pump is	Close the lid correctly.
ing machine.
	not correctly closed.
	Washing is caught in the	Abort the program, remove
		the washing caught in the
	door.
		door, start a new program.
Fabric softener is not	Suction cap in the compart-
added, w compart-		Clean the detergent com-
	ment for fabric softener is
ment for fabric sof-		partment, fit the suction cap
	not correctly fitted or is
tener is filled with		on firmly.
	blocked.
water.
Washing has not been	Rinse hold is selected.	Deselect Rinse hold.
		Pump out the water and set
spun, there is water left	The soaking program has
in the drum.		the main wash cycle
	been completed.
		required.

31