AEG 1046 EL, 1246 EL manual Positioning, Levelling, Water inlet

Page 40

132986190.qxd 16/02/2005 11:56 Pagina 40

Installation

Positioning

Install the machine on a flat hard floor.

Make sure that air circulation around the machine is not impeded by carpets, rugs etc.

•Before placing it on small tiles, apply a rubber coating.

•Never try to correct any unevenness in the floor by putting pieces of wood, cardboard or similar materials under the machine.

•If it is impossible to avoid positioning the machine next to a gas cooker or coal-burning stove, an insulating panel (85x57 cm) covered with aluminium foil on the side facing the cooker or stove, must be inserted between the two appliances;

•The machine must not be installed in rooms where the temperature can drop below 0.

•The water inlet hose and the drain hose must not be kinked.

•Please ensure that when the appliance is installed, it is easily accessi- ble for the engineer in the event of a breakdown.

Levelling

Carefully level by screwing the adjustable feet in or out. Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the floor.

Water inlet

Connect the water inlet hose supplied with the machine to a separate tap with a 3/4" thread. Do not use already employed hoses.

Important!

Before connecting up the machine to new pipework or to pipework that has not been used for some time, run off a reasonable amount of water to flush out any debris that may have collected in the pipes.

40

Image 40

Contents Washing Machine Instruction Booklet Dear customer Contents Programme charts wash and special programmes Safety instructions General safetyPositioning, connection, starting up Follow the instructions for positioning and connectionChild safety Proper useDisposal Tips for environmental protectionPackaging materials MachineMain features of your washing machine Description of the appliance Front viewControl panel Programme selector dialDelay Start button START/PAUSE buttonProgramme Option buttons PrewashDisplay 1046EL 1246ELProgramme progress display Altering a programme which is running Cancelling a programmeOpening the door after the programme has started Detergent dispenser drawer Before the first washPreparing the wash cycle Sorting out and preparing the laundryWeight of laundry Sort of laundry Approximate Dry weightsTypes of fabric and care labels CottonDelicates Detergents and additives Load the laundry How to washAdd detergent and additive Selection of the spin speed or Rinse Hold option Selection of the desired options1046 EL 1246 EL Selection of the Extra Rinse option Selection of the Delay Start optionBefore starting Starting the programme At the end of the programme Programme chart Wash programmesDescrip Special programmesMax Consumption Tion Cleaning and maintenance Periodical cleaning ExteriorAfter each wash Detergent dispenser drawerDrain pump Door sealWater inlet filter Frost precautions Emergency emptying outProblem Possible cause Solution TroubleshootingSomething not working? Problem Possible cause SolutionProblem Possible cause DistributedUnsatisfactory washing results If grey stains remain on the laundryFoam is still visible even after the last rinse White residue is left on the laundryTechnical data This appliance complies with the following EC directivesService Instructions for installation and electrical connection Safety instructions for the installerFront view and side view Dimensions of the applianceRear view Installation UnpackingLevelling PositioningWater inlet Water drainage Electrical connectionPermanent connection Connect the machine to an earthed socketQxd 16/02/2005 1156 Pagina From the Electrolux Group. The world’s No choice